Related Experiment Video
Updated: Nov 1, 2025

Four-Dimensional CT Analysis Using Sequential 3D-3D Registration
Published on: November 23, 2019
Three dimensional CT analysis of the change in rotational alignment in double level osteotomy after double level
Shunichiro Kambara1, Hiroshi Nakayama2, Ryo Kanto2
1Department of Orthopaedic Surgery, Nishinomiya Kaisei Hospital, 1-4 Oohama-cho, Nishinomiya, Hyogo, 662-0957, Japan.
Purpose:
To analyze the change in rotational alignment caused by double level osteotomy (DLO) based on comparative three-dimensional image analysis of pre- and postoperative CT images.
Methods:
Pre- and postoperative CT examination of the lower extremities were performed with informed consent for 39 consecutive knees undergoing DLO for varus knee deformity. The DLO procedure consisted of closed wedge distal femoral osteotomy (CWDFO) and open wedge high tibial osteotomy (OWHTO). Among those cases, 20 knees complicated with hinge fracture at the osteotomy site were excluded from the analysis to eliminate a confounding factor affecting the results. Consequently, data obtained from 19 knees were subjected to the study analysis while osteotomies with hinge fractures complications were excluded from the study. In the three-dimensional CT image analysis of axial plane images, femoral torsion (the angle between midline along the femoral neck axis and the tangent of the posterior edges of the medial/lateral femoral condyles) and tibial torsion (the angle between the tangent of the posterior edges of the medial/lateral tibial condyles and the transmalleolar axis) were measured. The torsion angle was measured in each of the femurs and the tibias on both pre- and postoperative CT axial images, and the change induced by the osteotomy was calculated and statistically(using Wilcoxon signed-rank test) compared.
Results:
The mean pre- and postoperative femoral torsion (anteversion) angles were 29.3° and 31.4° with a significant postoperative increase in internal rotation of the bony segment distal to the osteotomy(P = 0.002). On the tibial side, the mean pre- and postoperative torsion angles were 26.5° and 25.7°, indicating no significant postoperative change(P = 0.199)(NS).
Conclusions:
This study showed that the DLO procedure (combining CWDFO and OWHTO) increased torsion (anteversion) of the femur by 2.1° on average while inducing no significant rotational change on the tibial side.
More Related Videos
08:15Three-Dimensional Preoperative Virtual Planning in Derotational Proximal Femoral Osteotomy
Published on: February 17, 2023
06:28Anterior Cruciate Ligament Transection and Synovial Fluid Lavage in a Rodent Model to Study Joint Inflammation and Posttraumatic Osteoarthritis
Published on: September 2, 2025