Study on the physicochemical characteristics and dust suppression performance of new type chemical dust suppressant...

Copper mine road dust is the major source of dust in mine operations. The dust produced on the road surface is a great hazard to the workers. Aiming at the road dust of an open-pit mine, this paper conducts a physical and chemical analysis of a new type of chemical dust suppressant. It is prepared by using sodium polyacrylate as a binder, sodium carbonate as a moisture absorbent, polyethylene glycol as a water-retaining agent, and alkyl glycoside as a surfactant. Physical and chemical characteristics and dust suppression performance of dust suppressant were tested. The results show that the dust suppressant has a pH of 11.03, a viscosity of 18.5 mPa·s, and a surface tension of 28.1 mN/m. The content of heavy metal ions contained is less than the maximum concentration defined by "The norms for the integrated treatment of copper mine acidic waste water." Under the same temperature condition, the greater the humidity, the stronger the hygroscopicity. Especially when the humidity is 30%, the hygroscopic effect is contrary to water. The dust suppressant also has good anti-evaporation properties, and it could maintain a moisture content of 4% to 5% after being placed at room temperature for 10 days. Compared with water, the dust suppressant has better performance of wind erosion, water erosion, and compression resistance. Under the same conditions, the loss rate of water is 2 times that of the dust suppressant, and the pressure of the dust suppressant sample is about 3 times that of water. The dust suppressant has a much higher dust removal efficiency for all dust and respirable dust than water under the same conditions. Finally, the test results and mechanism of the dust suppression mechanism of the dust suppressant are described and analyzed, which shows that the dust suppressant studied in this paper has good performance and is suitable for road dust prevention.