Related Experiment Video
Updated: Nov 1, 2025

Physical, Chemical and Biological Characterization of Six Biochars Produced for the Remediation of Contaminated Sites
Published on: November 28, 2014
Relative proportions of organic carbon functional groups in biochars as influenced by spectral data collection and
Sirajum Munira1, James J Dynes2, Mofizul Islam3
1Department of Soil Science, Faculty of Agricultural & Food Sciences, University of Manitoba, 362 Ellis Building, Winnipeg, MB, R3T 2N2, Canada.
Abstract:
Solid-state 13C Nuclear Magnetic Resonance (NMR) and synchrotron-based X-ray Absorption Near-Edge Structure (XANES) have applications for determining the relative proportions of organic C functional groups in materials. Spectral data obtained by NMR is typically processed using integration (INTEG) whereas XANES spectral data is typically processed using deconvolution (DECONV). The objective of this study was to examine the impact of spectral data collection and processing on the estimated relative proportions of organic C functional groups in biochars. Biochars showed large variations in aromatic C (45-97%), alkyl C (0-23%), O-alkyl C (1-41%), phenolic C (0-20%) and carboxylic C (0-20%). NMR had a better ability than XANES to differentiate % aromatic C across biochars, and the mean % aromatic C was always greater for NMR-INTEG and NMR-DECONV than for XANES-INTEG or XANES-DECONV. NMR-INTEG showed significant associations with NMR-DECONV and XANES-INTEG for % aromatic C and alkyl C, but there were no significant associations between NMR and XANES for % O-alkyl C, phenolic C and carboxylic C. As well, there was no association between NMR-INTEG and XANES-DECONV for any organic C functional group, and in some cases, spectral data collection and processing influenced the quantification of organic C functional groups in a given biochar to the extent that the differences observed were as large as differences observed between biochars when analyzed using the same spectral data collection and processing technique. We conclude that great caution must be taken when comparing studies that determined organic C functional groups in materials using NMR-INTEG versus XANES-DECONV.
More Related Videos
08:57Improving Infrared Spectroscopy Characterization of Soil Organic Matter with Spectral Subtractions
Published on: January 10, 2019
08:12Characterization, Quantification and Compound-specific Isotopic Analysis of Pyrogenic Carbon Using Benzene Polycarboxylic Acids BPCA
Published on: May 16, 2016
Related Concept Videos
Spectroscopy of Carboxylic Acid Derivatives
What is Organic Chemistry?
IR and UV–Vis Spectroscopy of Carboxylic Acids
However, the stretching absorptions for the C=O bond vary depending on the structure of carboxylic acids. The C=O bond of the free carboxylic acids shows a higher stretching frequency, 1760 cm−1, while H-bonded carboxylic acids (dimers) exhibit stretching absorptions at a lower frequency,...
Introduction to Functional Groups
Functional groups are group of atoms with specific chemical properties that occur within organic molecules and sometimes denoted as “R”. Functional groups are found along the carbon backbone of macromolecules can form chains or rings of carbon atoms. Functional groups can “functionalize” a compound by enabling it to adopt different physical and chemical properties.
Types of common functional groups
The table below summarizes some of the major functional groups in organic chemistry....
IR Frequency Region: Fingerprint Region
NMR Spectroscopy of Aromatic Compounds