Coagulation patterns and the impacts on traffic-related ultrafine particle dispersion in road tunnels employing...

.In this study, we continue to analyze the diffusion mechanism of ultrafine particles and the particle coagulation phenomenon with a size range of 26-287 nm exhausted from vehicles during the process of passing through a 100-m-long tunnel using the realizable k-ε model and dynamic grid technique. A three-dimensional model consisting of a 100-m highway tunnel and four side-by-side gasoline vehicles (L × W × H = 4.5 m × 1.8 m × 1.5 m) was established in the STAR-CCM+ computational fluid dynamics software. The gasoline vehicles traveled simultaneously under different situations of three driving speeds of 60 km h^-1, 40 km h^-1, and 20 km h^-1 during the simulation. Through data analysis and research, it was found that the coagulation process of particles is very complicated, especially at low speeds. When the vehicle speed is 20 km h^-1, the variation in particle concentration at the vehicle wake near the tailpipe (at the vertical plane located 0.1 m behind the exhaust pipe) causes a large error if the coagulation action is not considered. The relative error of the average particle concentration at 0.5 s of the vertical section 0.1 m away from the exhaust pipe is as high as 193.51%. The relative error in the entire tunnel is only 2.82%, which is less than 5%. Thus, it is recommended that particle coagulation should be considered when analyzing particle dispersion in the near-wake region behind the vehicle and the breathing areas, especially when the vehicle travels slowly inside the tunnel. However, when evaluating the particle concentration and exposure levels for the entire tunnel, coagulation can be ignored without significant errors, especially at a high vehicle speeds. This study clarified the importance of coagulation in different areas and its influence on the diffusion of particulate matter. This is conducive to further analysis of the diffusion characteristics of particulate matter and can appreciably reduce the pollution degree in a tunnel by changing the coagulation efficiency of particulate matter in the future.