Related Experiment Video
Updated: Oct 31, 2025

Continuous-Wave Propagation Channel-Sounding Measurement System - Testing, Verification, and Measurements
Published on: June 25, 2021
Large-scale radio propagation path loss measurements and predictions in the VHF and UHF bands
Nasir Faruk1,2, I Y Abdulrasheed3, N T Surajudeen-Bakinde3
1Department of Telecommunication Science University of Ilorin, Nigeria.
Abstract:
For decades now, a lot of radio wave path loss propagation models have been developed for predictions across different environmental terrains. Amongst these models, empirical models are practically the most popular due to their ease of application. However, their prediction accuracies are not as high as required. Therefore, extensive path loss measurement data are needed to develop novel measurement-oriented path loss models with suitable correction factors for varied frequency, capturing both local terrain and clutter information, this have been found to be relatively expensive. In this paper, a large-scale radio propagation path loss measurement campaign was conducted across the VHF and UHF frequencies. A multi-transmitter propagation set-up was employed to measure the strengths of radio signals from seven broadcasting transmitters (operating at 89.30, 103.5, 203.25, 479.25, 615.25, 559.25 and 695.25 MHz respectively) at various locations covering a distance of 145.5 km within Nigerian urban environments. The measurement procedure deployed ensured that the data obtained strictly reflect the shadowing effects on radio signal propagation by filtering out the small-scale fading components. The paper also, examines the feasibilities of applying Kriging method to predict distanced-based path losses in the VHF and UHF bands. This method was introduced to minimize the cost of measurements, analysis and predictions of path losses in built-up propagation environments.
More Related Videos
10:00Calibration of Vector Network Analyzer for Measurements in Radio Frequency Propagation Channels
Published on: June 2, 2020
10:35Using Microwave and Macroscopic Samples of Dielectric Solids to Study the Photonic Properties of Disordered Photonic Bandgap Materials
Published on: September 26, 2014
Related Concept Videos
Lossless Lines
Propagation Speed of Electromagnetic Waves
Boundary Conditions: Lossless Lines
At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
Lossy Lines and Overvoltages
Attenuation
When constant series resistance and shunt conductance are present, voltage and current equations are modified. The propagation constant indicates that voltage and current waves consist of both forward and backward traveling components. These waves attenuate as they propagate, with the attenuation factor related to the resistance and conductance. In a...
Traveling Waves: Lossless Lines
Interference: Path Lengths
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...