Stress Corrosion Cracking Behavior of TP 439 and 690 TT under Film-Forming Amine Environment

Film-forming amines have been widely used in thermal power plants for maintenance after shutdown, and there are more and more applications and researches in nuclear power secondary circuits for this purpose. However, in the direction of stress corrosion cracking, there is not much research on the influence of film-forming amines on metal materials. This article uses the high temperature slow strain rate test (SSRT) method to evaluate the influence of a commercial film-forming amine on the stress corrosion cracking behavior of two conventional island materials for PWR nuclear power plants. These two metal materials are the heat exchange tube materials of the high-pressure heater and steam generator in the high-temperature operation area of the secondary circuit of a nuclear power plant: TP 439 stainless steel and 690 TT alloy. The test analyzed the mechanical properties and fracture morphology. The test results show that in the test concentration range (<5 mg/kg), the film-forming amine will not affect the SCC of TP 439 stainless steel and 690 TT alloy under the condition of slow strain rate. The behavior has a significant impact. In practical applications, the general dosage of film-forming amine is 1-2 mg/kg. This data is lower than the film-forming amine concentration used in the experiment. Therefore, there is no need to worry about the obvious impact on the SCC behavior of TP 439 stainless steel and 690 TT alloy.