Editorial Commentary: Causes of Failure After Arthroscopic Rotator Cuff Repair

Causes of failure after arthroscopic rotator cuff repair include patient factors, tear factors, and surgical factors. Failure may occur at the suture-tendon interface, the bone-tendon interface, or the bone-anchor interface. Low bone mineral density (BMD) in the greater tuberosity has been reported as a prognostic factor for recurrent tears following rotator cuff repair, and although most studies suggest the tendon-to-suture interface as the "weakest link," patients with low BMD may have lower suture anchor pull-out strength. A potential alternative cause of failure is the suture cutting through the greater tuberosity bone in patients with low BMD. Knotless suture bridge constructs or single-row constructs may be more susceptible to a suture cutting through the bone. The knotted suture bridge technique, wherein the medial mattress sutures are tied, may to some extent "shield" against complete cut-through. When bone quality appears poor, a common response is to change the type of anchor, size of anchor, or the location of the anchor. Other factors, such as bone preparation, suture type, suture tensioning, and anchor type (e.g., internal vs external locking), may all potentially affect suture cutting through weak bone.