Related Experiment Video
Updated: Oct 26, 2025

Split Point Analysis and Uncertainty Quantification of Thermal-Optical Organic/Elemental Carbon Measurements
Published on: September 7, 2019
Predicting wildfire particulate matter and hypothetical re-emission of radiological Cs-137 contamination incidents
Kirk R Baker1, Sang Don Lee1, Paul Lemieux1
1U.S. Environmental Protection Agency, Research Triangle Park, NC, USA.
Abstract:
Radiological release incidents can potentially contaminate widespread areas with radioactive materials and decontamination efforts are typically focused on populated areas, which means radionuclides may be left in forested areas for long periods of time. Large wildfires in contaminated forested areas have the potential to reintroduce these radionuclides into the atmosphere and cause exposure to first responders and downwind communities. One important radionuclide contaminant released from radiological incidents is radiocesium (137Cs) due to high yields and its long half-life of 30.2 years. An Eulerian 3D photochemical transport model was used to estimate potential ambient impacts of 137Cs re-emission due to wildfire following hypothetical radiological release scenarios. The Community Multiscale Air Quality (CMAQ) model did well at predicting levels and periods of increased PM2.5 carbon due to wildfire smoke at routine surface monitors in California during the summer of 2016. The model also did well at capturing the extent of the surface mixing layer compared to aerosol lidar measurements. Emissions from a large hypothetical wildfire were introduced into the wildland-urban interface (WUI) impacted by a hypothetical radiological release event. While ambient concentrations tended to be highest near the fire, the highest population committed effective dose equivalent by inhalation to an adult from 137Cs over an hour was downwind where wind flows moved smoke to high population areas. Seasonal variations in meteorology (wind flows) can result in differential population impacts even in the same metropolitan area. Modeled post-incident ambient levels of 137Cs both near these wildfires and further downwind in nearby urban areas were well below levels that would necessitate population evacuation or warrant other protective action recommendations such as shelter-in-place. These results suggest that 1) the modeling system captures local to regional scale transport and levels of PM2.5 from wildfire and 2) first responders and downwind population would not be expected to be at elevated risk from the initial inhalathion exposure of 137Cs re-emission.
More Related Videos
09:18Laser-heating and Radiance Spectrometry for the Study of Nuclear Materials in Conditions Simulating a Nuclear Power Plant Accident
Published on: December 14, 2017
11:19Measuring Carbon-based Contaminant Mineralization Using Combined CO2 Flux and Radiocarbon Analyses
Published on: October 21, 2016
Related Concept Videos
Biological Effects of Radiation
Radioactive Decay and Radiometric Dating
Types of Radioactivity
Alpha (α) decay is the emission of an α particle from the nucleus. For example, polonium-210 undergoes α decay:
Steps in Outbreak Investigation
Radiation Pressure: Problem Solving
The average value of the rate of momentum transfer divided by the absorbing area represents the average force...