Production of nanocellulose gels and films from invasive tree species

Wood from invasive tree species Acacia dealbata and Ailanthus altissima was used to produce high value-added nanocellulose. Firstly, bleached pulps were produced from the wood of these tree species after kraft cooking. Afterwards, the resultant pulps were pre-treated by TEMPO-mediated oxidation (Acacia dealbata) or enzymatic hydrolysis (Ailanthus altissima) followed by high-pressure homogenization. Hydrogels were obtained and characterized for their main physical and chemical properties, including rheology measurements. After freeze-drying, the surface properties of the materials were evaluated by inverse gas chromatography. Results showed that nano/micro fibrils could be obtained from the wood of these invasive species. Rheometry studies showed that Acacia-TEMPO cellulose nanofibrils form strong gels with high yield stress point and viscosities (reaching ca. 100,000 Pa·s). Additionally, the surfaces of the obtained nanocelluloses showed a dispersive component of the surface energy near 40 mJ/m² and a prevalence of the Lewis acidic character over the basic one, as typical for cellulose-based materials. Finally, films with good mechanical and optical properties could be obtained from the cellulose hydrogels. Acacia-TEMPO film (produced by filtration/hot pressing) showed a tensile strength of 79 MPa, Young's modulus of 7.9 GPa, and a transparency of 88%. The water vapor barrier, however, was modest (permeability of 4.9 × 10^-6 g/(Pa·day·m)).