Related Experiment Video
Updated: Oct 24, 2025

Automation of Mode Locking in a Nonlinear Polarization Rotation Fiber Laser through Output Polarization Measurements
Published on: February 28, 2016
Saturation-Tolerant Prescribed Control for a Class of MIMO Nonlinear Systems
Abstract:
This article proposes a saturation-tolerant prescribed control (SPC) for a class of multiinput and multioutput (MIMO) nonlinear systems simultaneously considering user-specified performance, unmeasurable system states, and actuator faults. To simplify the control design and decrease the conservatism, tunnel prescribed performance (TPP) is proposed not only with concise form but also smaller overshoot performance. By introducing non-negative modified signals into TPP as saturation-tolerant prescribed performance (SPP), we propose SPC to guarantee tracking errors not to violate SPP constraints despite the existence of saturation and actuator faults. Namely, SPP possesses the ability of enlarging or recovering the performance boundaries flexibly when saturations occur or disappear with the help of these non-negative signals. A novel auxiliary system is then constructed for these signals, which bridges the associations between input saturation errors and performance constraints. Considering nonlinearities and uncertainties in systems, a fuzzy state observer is utilized to approximate the unmeasurable system states under saturations and unknown actuator faults. Dynamic surface control is employed to avoid tedious computations incurred by the backstepping procedures. Furthermore, the closed-loop state errors are guaranteed to a small neighborhood around the equilibrium in finite time and evolved within SPP constraints although input saturations and actuator faults occur. Finally, comparative simulations are presented to demonstrate the feasibility and effectiveness of the proposed control scheme.
Related Concept Videos
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
BIBO stability of continuous and discrete -time systems
To determine the BIBO stability, the convolution integral is utilized when a bounded continuous-time input is applied to a Linear Time-Invariant (LTI) system....
Classification of Systems-I
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...
Transmission-Line Differential Equations
Line Section Model
A circuit representing a line section of length Δx helps in understanding the transmission line parameters. The voltage V(x) and current i(x) are measured...
Linear Approximation in Frequency Domain
In contrast, nonlinear systems do not inherently possess these properties. However, for small deviations around an operating point, a nonlinear system can often be approximated as linear....

