Characterizing Trophic State in Tropical/Subtropical Reservoirs: Deviations among Indexes in the Lower Latitudes

Davi Gasparini Fernandes Cunha1, Nícolas Reinaldo Finkler2, Marta Condé Lamparelli3

  • 1Departamento de Hidráulica e Saneamento, Escola de Engenharia de São Carlos, Universidade de São Paulo, São Carlos, SP, Brasil. davig@sc.usp.br.

Environmental Management
|August 17, 2021
PubMed

Related Concept Videos

Trophic Efficiency00:46

Trophic Efficiency

Trophic level transfer efficiency (TLTE) is a measure of the total energy transfer from one trophic level to the next. Due to extensive energy loss as metabolic heat, an average of only 10% of the original energy obtained is passed on to the next level. This pattern of energy loss severely limits the possible number of trophic levels in a food chain.
22.6K
Trophic Levels01:35

Trophic Levels

All organisms in an ecosystem occupy a trophic level in the food chain. The lowest level consists of primary producers, which synthesize their food from either solar or chemical energy. Each subsequent level obtains energy from the levels below. Detritivores can occupy any of the levels above primary producers.
33.7K
What is an Ecosystem?01:17

What is an Ecosystem?

Overview
43.1K
Primary Production01:06

Primary Production

The total amount of energy acquired by primary producers in an ecosystem is called gross primary production (GPP). However, of this energy, producers use some for metabolic processes, and some is lost as heat, decreasing the amount of energy available to the next trophic level. The remaining usable amount of energy is called the net primary productivity (NPP). In terrestrial ecosystems, NPP is driven by climate, while light penetration and nutrient availability drive NPP in aquatic ecosystems.
24.3K
Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
313
Tonicity in Animals01:16

Tonicity in Animals

Tonicity describes the amount of solute in a solution. The measure of the tonicity of a solution, or the total amount of solutes dissolved in a specific amount of solution, is called its osmolarity. Three terms—hypotonic, isotonic, and hypertonic—are used to relate the osmolarity of a cell to the osmolarity of the extracellular fluid that contains the cells. In a hypotonic solution, such as tap water, the extracellular fluid has a lower concentration of solutes than the fluid inside...
4.8K