Magnetic Resonance Imaging for Breast Tumor Bed Delineation: Computed Tomography Comparison and Sequence Variation

Our purpose was to investigate the interobserver variability in breast tumor bed delineation using magnetic resonance (MR) compared with computed tomography (CT) at baseline and to quantify the change in tumor bed volume between pretreatment and end-of-treatment MR for patients undergoing whole breast radiation therapy.

Forty-eight patients with breast cancer planned for whole breast radiation therapy underwent CT and MR (T1, T1 fat-suppression [T1fs], and T2) simulation in the supine treatment position before radiation therapy and MR (T1, T1fs, and T2) at the end of treatment in the same position. Two observers delineated 50 tumor beds on the CT and all MR sequences and assigned cavity visualization scores to the images. The primary endpoint was interobserver variability, measured using the conformity index (CI).

The mean cavity visualization scores at baseline were 3.14 (CT), 3.26 (T1), 3.41 (T1fs), and 3.58 (T2). The mean CIs were 0.65, 0.65, 0.72, and 0.68, respectively. T1fs significantly improved interobserver variability compared with CT, T1, or T2 (P < .001, P < .001, and P = .011, respectively). The CI for T1fs was significantly higher than T1 and T2 at the end of treatment (mean 0.72, 0.64, and 0.66, respectively; P < .001). The mean tumor bed volume on the T1fs sequence decreased from 18 cm³ at baseline to 13 cm³ at the end of treatment (P < .01).

T1fs reduced interobserver variability on both pre- and end-of-treatment scans and measured a reduction in tumor bed volume during whole breast radiation therapy. This rapid sequence could be easily used for adaptive boost or partial breast irradiation, especially on MR linear accelerators.