Related Experiment Video
Updated: Oct 23, 2025

A Method to Test the Efficacy of Handwashing for the Removal of Emerging Infectious Pathogens
Published on: June 7, 2017
Identifying drivers for user preference and acceptability of different hydro-alcoholic hand rub formulations
D Verwilghen1, K Osiak2, A D Shaw3
1University Teaching Hospitals Camden, Sydney School of Veterinary Sciences, Faculty of Science, University of Sydney, Australia; Altano Group, Dülmen, Germany.
Background:
In the current era, the importance of proper hand hygiene to reduce the transmission of infectious diseases has become difficult to debate. Yet, compliance rates remain low and are affected by many factors, amongst which is user acceptability of hand hygiene products.
Aim:
The present study aimed at investigating drivers of preference towards different hand hygiene formulations.
Methods:
Three different formulations (liquid, foam and gel) of the same brand were randomly and blindly evaluated by 54 participants based on the WHO Protocol for Evaluation of Tolerability and Acceptability of Alcohol-based Handrubs.
Results:
The majority (76%) of respondents indicated that the product formulation impacted their level of compliance with hand hygiene protocols. The preferred formulation was liquid, with 50% of participants ranking it as first choice. General product satisfaction, the product texture, the drying speed and the ease of application, were the statistically significant drivers for participants to rank a formulation as their first choice vs not ranking it as their first choice.
Conclusions:
When designing alcohol formulations and implementing hand hygiene protocols, understanding drivers of preference for formulations may enhance product user acceptability and therefore compliance with hand hygiene.
Related Concept Videos
Hand hygiene
Hand washing...
Physical Properties of Alcohols and Phenols
Alcohols possess a higher boiling point than aliphatic hydrocarbons of...
Handwashing III: During the Procedure and Post-Procedure Steps
Handwashing I: Introduction and Types of Equipment
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated....
Handwashing II: Pre-procedure and Initial Procedure Steps
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury. The nails must be short and clean, without nail...
Drug Dissolution: Requirements and Profile Comparison

