Regulation of carboxylester lipase adsorption to surfaces. 2. Physical state specificity

The physical specificity of adsorption of porcine pancreatic carboxylester lipase to mixed-lipid surfaces was examined by using films at the argon-buffer interface. They were comprised of 1-palmitoyl-2-oleoylphosphatidylcholine and triolein, 1,3-diolein, methyl oleate, oleonitrile, oleyl alcohol, or 13,16-docosadienoic acid. Under conditions where the surfaces are thermodynamically well-defined, each of these binary systems exhibits the formation of a lipid-lipid complex that is completely miscible with uncomplexed non-phospholipid [Smaby, J. M., & Brockman, H. L. (1985) Biophys. J. 48, 701-707]. Initial rates of adsorption of enzyme to the complexes were less than or equal to 5% of those measured in the absence of phospholipid and comparable to its rate of adsorption to phospholipid alone. This occurred despite there being up to 46% of the surface area occupied by non-phospholipid in the complexes. Equilibrium binding measurements were made at a composition where phospholipid-fatty acid complex was the predominant species. These showed that the low rates were due to an absence of adsorption sites relative to surfaces of fatty acid alone. With diolein or fatty acid and phospholipid, equilibrium binding was also measured at compositions intermediate between that of the complex and pure non-phospholipid. In both systems surface concentrations of enzyme varied nonideally with respect to either the mole fraction or area fraction of complex and uncomplexed diolein or fatty acid in the film. At area fractions of uncomplexed lipid of 0.35 and 0.67, dissociation constants for enzyme adsorption were increased 10-20-fold relative to pure fatty acid or diolein.(ABSTRACT TRUNCATED AT 250 WORDS)