Optimization for the conditions to prepare sewage sludge derived adsorbent and ciprofloxacin adsorption

In the present study, sewage sludge (SS) was used to synthesize activated carbon (AC) which was further utilized as adsorbent for the removal of ciprofloxacin (CPX) from synthetic wastewater. The adsorbent was prepared by chemical activation method using ZnCl₂ as activating agent. Design of experiments (DOE) approach was explored to determine the optimum operating conditions for the synthesis of AC and CPX removal from the wastewater. The optimum conditions for AC synthesis (i.e., carbonization temperature = ~500°C, activation time = 30 min, and impregnation ratio = 2.26) were decided based on results for three response parameters, that is, adsorbent yield, methylene blue removal, and iodine number. The synthesized adsorbent showed ~93% CPX removal (initial CPX concentration = 100 mg/L) at the following optimum conditions: adsorbent dose = 1.31 g/L, pH = 7 and reaction time = 12 h. Langmuir isotherm model was best fit to the equilibrium adsorption data (maximum adsorption capacity of SS derived AC = 102 mg/g) whereas pseudo-second order model showed the best fit to adsorption kinetic data (adsorption capacity = 77.5 mg/g). An effort was also made to reduce fresh water requirement for adsorbent synthesis by recycling the wastewater produced during chemical activation of SS. PRACTITIONER POINTS: Experiment design approach was used for optimization of adsorbent preparation conditions and CPX removal conditions by waste derived adsorbent. Sewage sludge derived adsorbent had BET surface area of 564 m² /g which is comparable to commercial activated carbon. 93% CPX adsorption with the sewage sludge derived adsorbent at optimum conditions. Langmuir model better suited the CPX adsorption data. Wastewater recycling and ZnO recovery from wastewater produced during adsorbent synthesis were performed.