Fit-for-purpose LC-MS/MS quantification of leukotoxin and leukotoxin diol in mouse plasma without sample...

LC/MS quantification of leukotoxin (LTX) and leukotoxin diol (LTXdiol) in plasma has been previously reported, however large sample volumes are required for achieving stated assay Lower Limit of Quantification (LLOQ). Reported here is a fit-for-purpose LC/MS method that reduces plasma volume from 700 to 25 µL and omits pre-concentration steps. These improvements make for a method with increased utility in mouse studies offering limited sample volumes. Additionally, omitting pre-concentration steps streamlines sample processing, which can now be completed in under 10 min. This method can be used to quickly answer if the ratio of LTX to LTXdiol changes with the dose of the therapeutic drug so this could be used as a potential biomarker for correlating PK/PD effects. No extensive assay characterization was performed before application to an exploratory in-life study. Basal levels of LTX and LTXdiol in plasma were quantified by LC-MRM across 10 individual mice, and the average signal-to-noise was 36 for LTX and 3039 for LTXdiol, with CVs of 29.4% and 15.2%, respectively. Addition of LTX and LTXdiol reference standard at 5, 25, and 75 ng/mL into pooled mouse plasma was quantifiable within 30% relative error using a surrogate matrix calibration curve ranging from 0.8 to 200 ng/mL. The average ratio of LTX to LTXdiol across the 10 mice was 0.32, consistent with previous reports. Finally, the method was applied to a mouse PK/PD study to monitor LTX/LTXdiol kinetics after a single oral dose of a soluble epoxide hydrolase inhibitor. The mean plasma ratio of LTX to LTXdiol increased up to 10-fold by 3 h post-dose followed by a decrease to near pre-dose levels by 24 h, consistent with transient inhibition of sEH-mediated conversion of LTX to LTXdiol. The method improvements described here will make subsequent quantification of LTX and LTXdiol in mouse studies significantly easier.