Emission inventory and control policy for non-road construction machinery in Tianjin

The establishment of a non-road construction machinery emission inventory forms the basis for the analysis of pollutant emission characteristics and for the formulation of control policy. We analyzed and investigated data on populations, emission factors, and activity levels for the construction machinery in Tianjin to estimate an emission inventory. Finally, a variety of emission reduction scenarios were used to simulate emission reductions and propose the most effective control policy. The results show that total emissions of CO, HC, NOx, PM₁₀, and PM_2.5 from non-road construction machinery in Tianjin of 2018 reached 4180.78, 951.44, 5833.85, 383.92, and 365.70 t, respectively. Forklifts, excavators, and loaders were the three most important emission sources in Tianjin. There are clear differences in the emissions of different districts. Large machinery emissions were mainly distributed across the Binhai New Area, which includes high volumes of port machinery and tractors in Tianjin Port. Based on various emission reduction scenarios, the effect of emission reductions is estimated. The IAD affected the reduction of CO and HC emissions with RR values of 17.6% and 17.3%, respectively, while EMO affected the mitigation of PM₁₀ and PM_2.5 emissions and RR values by 18.0% and 18.4%, respectively. The emission reduction control policy for non-road construction machinery is proposed, including the accelerated updating of non-road machinery emission standards; integrating diesel engine research and development institutions to accelerate the development of vehicle after-treatment technology; and establishing a cooperation mechanism for scientific research institutes, government departments, and enterprises in the control of non-road mobile machinery emissions.