Related Experiment Video
Updated: Oct 21, 2025
Printing Thermoresponsive Reverse Molds for the Creation of Patterned Two-component Hydrogels for 3D Cell Culture
Published on: July 10, 2013
Semi-solid extrusion 3D printing of starch-based soft dosage forms for the treatment of paediatric latent
Aikaterini-Theodora Chatzitaki1, Emmanouela Mystiridou2, Nikolaos Bouropoulos2,3
1Laboratory of Pharmaceutical Technology, Department of Pharmacy, School of Health Sciences, Aristotle University of Thessaloniki, Thessaloniki, Greece.
Objectives:
The development of age-appropriate dosage forms is essential for effective pharmacotherapy, especially when long-term drug treatment is required, as in the case of latent tuberculosis infection treatment with up to 9 months of daily isoniazid (ISO). Herein, we describe the fabrication of starch-based soft dosage forms of ISO using semi-solid extrusion (SSE) 3D printing.
Methods:
Corn starch was used for ink preparation using ISO as model drug. The inks were characterized physicochemically and their viscoelastic properties were assessed with rheological analysis. The morphology of the printed dosage forms was visualized with scanning electron microscopy and their textural properties were evaluated using texture analysis. Dose accuracy was verified before in-vitro swelling and dissolution studies in simulated gastric fluid (SGF).
Key Findings:
Starch inks were printed with good resolution and high drug dose accuracy. The printed dosage forms had a soft texture to ease administration in paediatric patients and a highly porous microstructure facilitating water penetration and ISO diffusion in SGF, resulting in almost total drug release within 45 min.
Conclusions:
The ease of preparation and fabrication combined with the cost-effectiveness of the starting materials constitutes SSE 3D printing of starch-based soft dosage forms a viable approach for paediatric-friendly formulations in low-resource settings.
