Corrigendum: Dripping, jetting and tip streaming (2020Rep. Prog. Phys.83097001)

There are many examples of pressure in fluids in everyday life, such as in relation to blood (high or low blood pressure) and in relation to weather (high- and low-pressure weather systems). A given force can have a significantly different effect, depending on the area over which the force is exerted. For instance, a force applied to an area of 1 mm2 has a pressure that is 100 times greater than the same force applied to an area of 1 cm2. That's why a sharp needle is able to poke through skin...

When a fluid is in constant acceleration, the pressure and buoyant force equations are modified. Suppose a beaker is placed in an elevator accelerating upward with a constant acceleration, a. In the beaker, assume there is a thin cylinder of height h with an infinitesimal cross-sectional area, ΔS.
The motion of the liquid within this infinitesimal cylinder is considered to obtain the pressure difference. Three vertical forces act on this liquid:

The shape of a small drop of liquid can be considered spherical, neglecting the effect of gravity. This drop can further be considered as two equal hemispherical drops put together due to surface tension. The forces acting on the spherical drop are due to the pressure of the liquid inside the drop, the pressure due to air outside the drop, and the force due to the surface tension acting on the two hemispherical drops.

Fluids can be classified into Newtonian and non-Newtonian fluids based on their response to shear stress. Newtonian fluids have a linear relationship between shear stress and the shear strain rate, following Newton's law of viscosity. Their viscosity remains constant regardless of the shear rate, making their behavior predictable and easier to analyze. Common examples include water, air, oil, and gasoline.
In contrast, non-Newtonian fluids do not follow Newton's law of viscosity, and their...

Free jets describe the flow of liquid exiting a reservoir through an opening into the atmosphere without resistance. The velocity (v) of the liquid jet is derived using Bernoulli's principle and expressed as:

When fluid enters a pipe, it first passes through the entrance region, where the velocity profile adjusts due to viscous effects. In this region, a boundary layer forms along the pipe walls and grows until it fully occupies the pipe's cross-section. Once the boundary layer merges, the flow becomes fully developed, with a steady velocity profile that remains consistent along the pipe's length.
The distance to reach a fully developed flow is called the entrance length and depends on the flow...