Estimating the variance of Shannon entropy

Leonardo Ricci1,2, Alessio Perinelli2, Michele Castelluzzo1

  • 1Department of Physics, University of Trento, 38123 Trento, Italy.

Physical Review. E
|September 16, 2021
PubMed

Related Concept Videos

Entropy02:39

Entropy

Salt particles that have dissolved in water never spontaneously come back together in solution to reform solid particles. Moreover, a gas that has expanded in a vacuum remains dispersed and never spontaneously reassembles. The unidirectional nature of these phenomena is the result of a thermodynamic state function called entropy (S). Entropy is the measure of the extent to which the energy is dispersed throughout a system, or in other words, it is proportional to the degree of disorder of a...
32.1K
Variance01:15

Variance

 The deviations show how spread out the data are about the mean. A positive deviation occurs when the data value exceeds the mean, whereas a negative deviation occurs when the data value is less than the mean. If the deviations are added, the sum is always zero. So one cannot simply add the deviations to get the data spread. By squaring the deviations, the numbers are made positive; thus, their sum will also be positive.
The standard deviation measures the spread in the same units as the...
11.0K
Entropy and the Second Law of Thermodynamics01:20

Entropy and the Second Law of Thermodynamics

The second law of thermodynamics can be stated quantitatively using the concept of entropy. Entropy is the measure of disorder of the system.
The relation  between entropy and disorder can be illustrated with the example of the phase change of ice to water. In ice, the molecules are located at specific sites giving a solid state, whereas, in a liquid form, these molecules are much freer to move. The molecular arrangement has therefore become more randomized. Although the change in average...
3.4K
Estimating Population Standard Deviation01:26

Estimating Population Standard Deviation

When the population standard deviation is unknown and the sample size is large, the sample standard deviation s is commonly used as a point estimate of σ. However, it can sometimes under or overestimate the population standard deviation. To overcome this drawback, confidence intervals are determined to estimate population parameters and eliminate any calculation bias accurately. However, this only applies to random samples from normally distributed populations. Knowing the sample mean and...
3.1K
Estimating Population Mean with Known Standard Deviation01:16

Estimating Population Mean with Known Standard Deviation

To construct a confidence interval for a single unknown population mean μ, where the population standard deviation is known, we need sample mean as an estimate for μ and we need the margin of error. Here, the margin of error (EBM) is called the error bound for a population mean (abbreviated EBM). The sample mean is the point estimate of the unknown population mean μ.
The confidence interval estimate will have the form as follows:
(point estimate - error bound, point estimate +...
9.0K
Estimating Population Mean with Unknown Standard Deviation01:22

Estimating Population Mean with Unknown Standard Deviation

In practice, we rarely know the population standard deviation. In the past, when the sample size was large, this did not present a problem to statisticians. They used the sample standard deviation s as an estimate for σ and proceeded as before to calculate a confidence interval with close enough results. However, statisticians ran into problems when the sample size was small. A small sample size caused inaccuracies in the confidence interval.
William S. Gosset (1876–1937) of the...
8.3K