Design and validation of an expeditious analytical method to quantify the emulsifying activity during...

Biosurfactants (BS) and bioemulsifiers (BE) are amphiphilic molecules that are produced by a wide range of microorganisms. Although the chemical composition of BS and BE is different, both BS/BE have recognized emulsifying properties, which are the focus of this study. Herein, a rapid and simple analytical method to quantify the emulsifying activity (EA) of a product produced by the actinomycete Gordonia alkanivorans strain 1B (BS/BE), which exhibits emulsifying properties, was developed. The analytical approach was based on the ability of a BS/BE solution to form a stable emulsion when mixed with n-heptane. So, using 4 mL screw cap glass tubes (10 × 75 mm, ND10 caps with PTFE septum), the EA was assessed by adding 1 mL of n-heptane to 1 mL of an aqueous solution containing the test product, mix by vortexing at high speed (2 min) and place the tube in an upright stable position for 10 _min before analyzing. A set of emulsification tests with increasing volumes of test product solutions was carried out until 100% emulsion was obtained in the organic phase. One emulsification unit was defined as the minimum volume of product (Vol_min of emulsifier/surfactant, up to 1 mL) needed to form and maintain 100% emulsion in the organic phase. The corresponding emulsifying activity value is presented in U/mL, and it is calculated as: EA (product) = 1 U/Vol_min (mL). Further validation by testing several synthetic surfactants and industrial/domestic dishwashing detergents, in parallel with the bacterial crude BS/BE, towards emulsifying activity determination (U/mL) was performed demonstrating the wide range of the method applicability. Moreover, the specific emulsifying activity for each product tested was estimated though correlation analysis (linear regression) between volumetric emulsifying activity (U/mL) and product concentration (g/L). Indeed, this new analytical approach to quantify the emulsifying activity is accurate and reproducible, and consequently it can be a promising tool to apply in screening/monitorization studies on BS/BE production enabling reliable comparisons.