Related Experiment Video
Updated: Oct 19, 2025

Setup of Consumer Wearable Devices for Exposure and Health Monitoring in Population Studies
Published on: February 3, 2023
Impacts of COVID-19 on residential building energy use and performance
1Department of Civil and Environmental Engineering, Michigan State University, East Lansing, MI, USA.
Abstract:
Following the declaration of the COVID-19 pandemic and the rise in cases across the United States, the typical daily routines of millions were disrupted as the country attempted to control the spread of the virus. As a result, homes became makeshift offices, classrooms, restaurants, and entertainment centers. With these changes in how residential buildings are used, surveys and grid-level studies have been conducted to understand how energy use has shifted due to the pandemic. However, there are limited efforts that review the impact of energy use at the household level. In this study, high-resolution, disaggregated data is analyzed to measure the shifts in electricity use related to HVAC loads, non-HVAC loads, and whole-home loads in a comparison of 225 housing units over the years of 2018-2020. Key findings from the analyses indicated increased electricity use during periods that occupants would usually be away from home. The most percent increases in non-HVAC residential loads occurred between 10 a.m. and 5 p.m.; HVAC loads increasing in total daily consumption compared to the same average daily temperatures of previous years. Additionally, dividing the data by household income, the lowest income and higher income households experienced the larger increases in consumption, while the middle income groups experience smaller shifts.
Related Concept Videos
Electrical Energy
Design Example: Sustainability in Concrete Building
There are multiple approaches to achieve sustainability in a commercial concrete building. For instance, construct a concrete parking area under the building, utilizing pervious concrete paver blocks in open areas to facilitate rainwater collection through an underground...
Thermal Insulation in Masonry Walls
External insulation can be applied using an Exterior Insulation and Finish System (EIFS), which involves affixing panels of plastic foam to the wall and covering them with a polymeric stucco reinforced with glass fiber mesh....
Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q, and its...
Effects of Air-entrainment in Concrete
Factors Affecting Pulmonary Ventilation
Alveolar Surface Tension
The alveolar fluid lines the luminal surface of the alveoli and exerts a force called surface tension. This force is caused by the polar water molecules in the liquid being more strongly attracted to each...

