Comparing Class-Aware and Pairwise Loss Functions for Deep Metric Learning in Wildlife Re-Identification

Nkosikhona Dlamini1, Terence L van Zyl2

  • 1Faculty of Science, Braamfontein Campus, School of Computer Science and Applied Mathematics, University of Witwatersrand, Johannesburg 2000, South Africa.

Sensors (Basel, Switzerland)
|September 28, 2021
PubMed

Related Concept Videos

Wilcoxon Signed-Ranks Test for Matched Pairs01:09

Wilcoxon Signed-Ranks Test for Matched Pairs

The Wilcoxon signed-rank test for matched pairs evaluates the null hypothesis by combining the ranks of differences with their signs. It essentially tests whether the median of the differences in a population of matched pairs is zero. Since the test incorporates more information than the sign test, it generally yields more trustable conclusions. This test also does not require the data to follow a normal distribution, but two conditions must be met for it to be applicable: (1) the data must...
242
Methods of Classification and Identification01:28

Methods of Classification and Identification

Bacterial identification relies on a diverse array of techniques to classify and understand microorganisms, each tailored to uncover specific characteristics. Traditional morphological approaches, while still valuable, are limited for closely related or structurally simple organisms. Modern methods integrate biochemical, serological, genetic, and advanced molecular tools to achieve greater accuracy.Morphological and Biochemical TechniquesMorphological characteristics, such as cell shape and...
340
Reducing Line Loss01:18

Reducing Line Loss

In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss...
220
Residuals and Least-Squares Property01:11

Residuals and Least-Squares Property

The vertical distance between the actual value of y and the estimated value of y. In other words, it measures the vertical distance between the actual data point and the predicted point on the line
If the observed data point lies above the line, the residual is positive, and the line underestimates the actual data value for y. If the observed data point lies below the line, the residual is negative, and the line overestimates the actual data value for y.
The process of fitting the best-fit...
8.1K
Classification of Signals01:30

Classification of Signals

In signal processing, signals are classified based on various characteristics: continuous-time versus discrete-time, periodic versus aperiodic, analog versus digital, and causal versus noncausal. Each category highlights distinct properties crucial for understanding and manipulating signals.
A continuous-time signal holds a value at every instant in time, representing information seamlessly. In contrast, a discrete-time signal holds values only at specific moments, often denoted as x(n), where...
1.0K
Classification of Systems-II01:31

Classification of Systems-II

Continuous-time systems have continuous input and output signals, with time measured continuously. These systems are generally defined by differential or algebraic equations. For instance, in an RC circuit, the relationship between input and output voltage is expressed through a differential equation derived from Ohm's law and the capacitor relation,
259