Related Experiment Video
Updated: Jun 28, 2026
09:19
Fabrication and Characterization of Disordered Polymer Optical Fibers for Transverse Anderson Localization of Light
Published on: July 29, 2013
Author Correction: Non-Gaussian tail in the force distribution: a hallmark of correlated disorder in the host media
Jazmín Aragón Sánchez1, Gonzalo Rumi1, Raúl Cortés Maldonado1
1Centro Atómico Bariloche and Instituto Balseiro, CNEA, CONICET and Universidad Nacional de Cuyo, 8400, San Carlos de Bariloche, Argentina.
Scientific Reports
|September 28, 2021
Abstract
No abstract available in PubMed .
Related Concept Videos
01:17Gauss's Law in Dielectrics
Consider a polar dielectric placed in an external field. In such a dielectric, opposite charges on adjacent dipoles neutralize each other, such that the net charge within the dielectric is zero. When a polar dielectric is inserted in between the capacitor plates, an electric field is generated due to the presence of net charges near the edge of the dielectric and the metal plates interface. Since the external electrical field merely aligns the dipoles, the dielectric as a whole is neutral. An...
01:12Temperature Dependent Deformation
In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added together...
01:15Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
Deformation occurs in axial and transverse directions when an axial load is applied to a slender bar. This deformation impacts the cubic element within the bar, transforming it into either a rectangular parallelepiped or a rhombus, contingent on its orientation. This transformation process induces shearing strain. Axial loading elicits both shearing and normal strains. Applying an axial load instigates equal normal and shearing stresses on elements oriented at a 45° angle to the load axis.
01:11Distribution of Stresses in a Narrow Rectangular Beam
In studying beam stress distribution, examining an elemental section is essential. To determine the average shearing stress on this face, the calculated shear is divided by the surface area. Importantly, shearing stresses on the beam's transverse and horizontal planes mirror each other, indicating a consistent stress distribution along the upper region of the beam. Notably, shearing stresses are absent at the beam's upper and lower surfaces due to the absence of applied forces in these areas.
01:22Elastic Strain Energy for Normal Stresses
Strain energy quantifies the energy stored within a material due to deformation under loading conditions, a fundamental concept in materials science and engineering. The strain energy can be modeled when a material is subjected to axial loading with uniformly distributed stress. In this scenario, the stress experienced by the material is the internal force divided by the cross-sectional area, and the strain induced is directly proportional to this stress through the modulus of elasticity.
If...
If...
01:20Elastic Strain Energy for Shearing Stresses
As discussed in previous lessons, strain energy in a material is the energy stored when it is elastically deformed, a concept crucial in materials science and mechanical engineering. This energy results from the internal work done against the cohesive forces within the material. When a material undergoes shearing stress and corresponding shearing strain, the strain energy density, which is the energy stored per unit volume, is calculated. Within the elastic limit, where the stress is...