Ion-Induced Phase Transfer of Cationic Dyes for Fluorescence-Based Electrolyte Sensing in Droplet Microfluidics

Fluorescence-based sensing in droplet microfluidics requires small sample volumes, allows for high-throughput assays, and does not suffer from photobleaching as each flowing sensor is only scanned one time. In this paper, we report a selective and sensitive fluorescence-based ion-sensing methodology in droplet microfluidics using a T-junction PDMS chip. The oil stream is doped with sensor ingredients including an ionophore, a cation exchanger, and a permanently cationic fluorophore as the optical reporter. Electrolyte cations from the aqueous sample are extracted into oil segments and displace the cationic dyes into aqueous droplets. Laser-induced fluorescence of the two immiscible phases is collected alternately, which is in clear contrast to most other ion-selective optode configurations such as nanoparticle suspensions that rely on mixed optical signals of two phases. The cation exchanger, tetrakis[3,5-bis(trifluoromethyl)phenyl]borate, is found to dramatically enhance the dye emission in the nonpolar sensing oil by preventing ion-pairing interactions and aggregations of the dye molecules, providing new insights into the mechanism of cationic dye-based ion sensors. The high dye brightness allows us to use low concentrations of sensing chemicals (e.g., 10 μM) in the oil and attain high sensitivity for detection of ions in an equal volume of sample. Using valinomycin as the ionophore and methylene blue as the dye, K⁺ is detected with a response time of ∼11 s, a logarithmic linear range of 10^-5 to 10^-2 M, a 20-fold total fluorescence response, >1000-fold selectivity against other electrolyte cations, and negligible cross-sensitivity toward the sample pH. The K⁺ concentration in untreated and undiluted whole blood and sweat samples is successfully determined by this microfluidic sensing method without optical interference from the droplet sample to the sensing oil. Detection of other ionic analytes can be achieved using the corresponding ionophores.