Polymer/silica hybrid 3D waveguide thermo-optic mode switch based on cascaded asymmetric directional couplers

A polymer/silica hybrid 3D waveguide thermo-optic (TO) mode switch based on cascaded asymmetric directional couplers (ADCs) is theoretically designed and simulated, where the spatial modes of a few-mode silica waveguide can be switched to various single-mode polymer waveguides placed above the few-mode silica waveguide. A beam propagation method is employed to optimize the dimensional parameters of the mode switch to convert the LP₁₁ and LP₁₁ modes of the few-mode silica waveguide to the LP₀₁ mode of two single-mode polymer waveguides using the cascaded ADC 1 and ADC 2. The coupling ratios are higher than 96.4% (93.4%) and 95.1% (92.8%) for the ADC 1 and ADC 2, respectively, under the TE (TM) polarization within the wavelength range from 1530 to 1570 nm, which shows good wavelength independence. Furthermore, the monolayer graphene is introduced as the heating electrode and buried on the surface of the polymer core to increase the heating efficiency and reduce the power consumption. The power consumption for ADC 1 and ADC 2 is 16.69 mW and 17.35 mW, respectively. Compared to the traditional TO switch with an aluminum (Al) heating electrode, the heating efficiency of the presented device can be improved by ∼30%. Moreover, the response speed of the TO mode switch with a 3D waveguide structure was also significantly improved. Compared to the device with Al electrodes, the introduced graphene electrodes can improve the switching speed of the device by ∼60%. The presented TO mode switch with its small size and easy integration should find applications in reconfigurable mode division multiplexing systems.