Related Experiment Video

Updated: Oct 17, 2025

Quasi-light Storage for Optical Data Packets
07:45

Quasi-light Storage for Optical Data Packets

Published on: February 6, 2014

11.0K

Research on the lossless contention MAC protocol and the performance of an ultraviolet communication network

Cheng Li, Jianhua Li, Zhiyong Xu

    Optics Express
    |October 7, 2021
    PubMed

    More Related Videos

    Large Scale Energy Efficient Sensor Network Routing Using a Quantum Processor Unit05:30

    Large Scale Energy Efficient Sensor Network Routing Using a Quantum Processor Unit

    Published on: September 8, 2023

    791
    Continuous-Wave Propagation Channel-Sounding Measurement System - Testing, Verification, and Measurements09:36

    Continuous-Wave Propagation Channel-Sounding Measurement System - Testing, Verification, and Measurements

    Published on: June 25, 2021

    3.2K

    Related Concept Videos

    Lossless Lines01:23

    Lossless Lines

    In electrical engineering, a lossless transmission line is characterized by a purely imaginary propagation constant and a resistive characteristic impedance. The ABCD parameters, which describe the relationship between the input and output voltages and currents, indicate an equivalent π circuit with an imaginary series impedance and a shunt admittance. This results in a transmission line that, when the product of the phase constant (beta) and the length of the line is less than pi,...
    191
    Ultraviolet and Visible (UV–Vis) Spectroscopy: Overview01:02

    Ultraviolet and Visible (UV–Vis) Spectroscopy: Overview

    Ultraviolet–visible (UV–visible or UV–Vis) spectroscopy is an analytical technique that investigates the interaction between matter and UV–Vis light within the electromagnetic spectrum. This method is widely used for its versatility, simplicity, and relatively quick data acquisition, making it valuable for both qualitative and quantitative analysis. When UV–Vis radiation passes through a material,  molecules absorb light depending on the energy required for...
    3.6K
    Boundary Conditions: Lossless Lines01:21

    Boundary Conditions: Lossless Lines

    Consider a single-phase, two-wire, lossless transmission line terminated by an impedance at the receiving end and a source with Thevenin voltage and impedance at the sending end. The line, with length, has a surge impedance and wave velocity determined by the line's inductance and capacitance.
    At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
    178
    Lossy Lines and Overvoltages01:22

    Lossy Lines and Overvoltages

    Transmission-line series resistance and shunt conductance cause three primary effects: attenuation, distortion, and power losses.
    Attenuation
    When constant series resistance and shunt conductance are present, voltage and current equations are modified. The propagation constant indicates that voltage and current waves consist of both forward and backward traveling components. These waves attenuate as they propagate, with the attenuation factor related to the resistance and conductance. In a...
    142
    Reducing Line Loss01:18

    Reducing Line Loss

    In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
    With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss...
    219
    Propagation Speed of Electromagnetic Waves01:30

    Propagation Speed of Electromagnetic Waves

    Electromagnetic waves are consistent with Ampere's law. Assuming there is no conduction current Ampere's law is given as:
    4.1K