Bioconversion of Organic Pollutants in Fish-Canning Wastewater into Volatile Fatty Acids and Polyhydroxyalkanoate

The wastewater from the cookers of a tuna-canning plant was used as feedstock for the process. It was acidified in a continuous stirred tank reactor (CSTR) of 1.5 L to produce a mixture of volatile fatty acids (VFAs). The effluent contained 28.3 ± 8.7 g COD_S/L and 25.0 ± 4.6 g COD_VFA/L, 4.4 ± 1.6 g NH₄⁺/L, and 10.9 ± 4.0 g Na⁺/L, which corresponds to about 28 g NaCl/L approximately. This was used to feed a PHA production system. The enriched MMC presented a capacity to accumulate PHAs from the fermented tuna wastewater. The maximum PHA content of the biomass in the fed-batch (8.35 wt% PHA) seemed very low, possibly due to the variable salinity (from 2.2 up to 12.3 g NaCl/L) and the presence of ammonium (which promoted the biomass growth). The batch assay showed a PHA accumulation of 5.70 wt% PHA, but this is a much better result if the productivity of the reactor is taken into account. The fed-batch reactor had a productivity of 10.3 mg PHA/(L h), while the batch value was about five times higher (55.4 mg PHA/(L h)). At the sight of the results, it can be seen that the acidification of fish-canning wastewater is possible even at high saline concentrations (27.7 g NaCl/L). On the other hand, the enrichment and accumulation results show us promising news and which direction has to be followed: PHAs can be obtained from challenging substrates, and the feeding mode during the accumulation stage has an important role to play when it comes to inhibition.