Fixed-Bed Column Technique for the Removal of Phosphate from Water Using Leftover Coal

The excessive discharge of phosphate from anthropogenic activities is a primary cause for the eutrophication of aquatic habitats. Several methodologies have been tested for the removal of phosphate from aqueous solutions, and adsorption in a flow-through reactor is an effective mechanism to reduce the nutrient loading of water. This research aimed to investigate the adsorption potential of leftover coal material to remove phosphate from a solution by using continuous flow fixed-bed column, and analyzes the obtained breakthrough curves. A series of column tests were performed to determine the phosphorus breakthrough characteristics by varying operational design parameters such as adsorbent bed height (5 to 8 cm), influent phosphate concentration (10-25 mg/L), and influent flow rate (1-2 mL/min). The amorphous and crystalline property of leftover coal material was studied using XRD technology. The FT-IR spectrum confirmed the interaction of adsorption sites with phosphate ions. Breakthrough time decreased with increasing flow rate and influent phosphate concentration, but increased with increasing adsorbent bed height. Breakthrough-curve analysis showed that phosphate adsorption onto the leftover coal material was most effective at a flow rate of 1 mL/min, influent phosphate concentration of 25 mg/L, and at a bed height of 8 cm. The maximal total phosphate adsorbed onto the coal material's surface was 243 mg/kg adsorbent. The Adams-Bohart model depicted the experimental breakthrough curve well, and overall performed better than the Thomas and Yoon-Nelson models did, with correlation values (R²) ranging from 0.92 to 0.98. Lastly, leftover coal could be used in the purification of phosphorus-laden water, and the Adams-Bohart model can be employed to design filter units at a technical scale.