Chemical and Structural Changes by Gold Addition Using Recharge Method in NiW/Al₂O₃-CeO₂-TiO₂ Nanomaterials

NiWAu trimetallic nanoparticles (NPs) on the surface of support Al₂O₃-CeO₂-TiO₂ were synthesized by a three-step synthetic method in which Au NPs were incorporated into presynthesized NiW/Al₂O₃-CeO₂-TiO₂. The recharge method, also known as the redox method, was used to add 2.5 wt% gold. The Al₂O₃-CeO₂-TiO₂ support was made by a sol-gel method with two different compositions, and then two metals were simultaneously loaded (5 wt% nickel and 2.5 wt% tungsten) by two different methods, incipient wet impregnation and ultrasound impregnation method. In this paper, we study the effect of Au addition using the recharge method on NiW nanomaterials supported on mixed oxides on the physicochemical properties of synthesized nanomaterials. The prepared nanomaterials were characterized by scanning electron microscopy, BET specific surface area, X-ray diffraction, diffuse reflectance spectroscopy in the UV-visible range and temperature-programmed desorption of hydrogen. The experimental results showed that after loading of gold, the dispersion was higher (46% and 50%) with the trimetallic nanomaterials synthesized by incipient wet impregnation plus recharge method than with impregnation plus ultrasound recharge method, indicating a greater number of active trimetallic (NiWAu) sites in these materials. Small-sized Au from NiWAu/ACTU1 trimetallic nanostructures was enlarged for NiWAu/ACT1. The strong metal NPs-support interaction shown for the formation of NiAl₂O₄, Ni-W-O and Ni-Au-O species simultaneously present in the surface of trimetallic nanomaterial probably plays an important role in the degree of dispersion of the gold active phase.