Fully-automated SPE coupled to UHPLC-MS/MS method for multiresidue analysis of 26 trace antibiotics in environmental waters: SPE optimization and method validation

Achieving simultaneous determination of antibiotic multiresidues in environmental waters by solid phase extraction (SPE) coupled with ultra-high-performance liquid chromatography tandem mass spectrometry (UHPLC-MS/MS) with detection limits ≤ ng L^-1 is still a huge challenge. Moreover, the offline SPE procedure was performed manually, costly, and time-consuming, while the online SPE required precision pretreatment instruments that require highly-skilled personnel. In this paper, a fully automated SPE coupled with UHPLC-MS/MS method was developed for analysis of antibiotics (sulfonamides, quinolones, and macrolides) in water matrices. Sample preparation optimization included SPE materials and configuration (HLB disks), sample volume (500-1000 mL), and pH (pH = 3) with a flow rate at 2~5 mL min^-1, and an elution procedure with 2 × 6 mL methanol, and 2 × 6 mL acetone. Meanwhile, the parameters for UHPLC-MS/S detection of analytes were optimized, including LC retention time, and MS parameters. The instrumental limits of detection (LOD) and quantification (LOQ) of analytes ranged from 0.01-0.72 μg L^-1 and 0.05-2.39 μg L^-1, respectively, with satisfactory linear calibration (R² > 0.995) and precision (< 9.9%). Recoveries in spike samples ranged between 77.5-104.9% in pure water, 59.4-97.8% in surface water (SW), and 58.2-108.6% in wastewater effluent (WWE) with relative standard deviations ≤ 12.8%. The matrix effects observed for most analytes were suppression (0-28.1%) except for five analytes having presented enhancement (0-14.6 %) in SW or WWE. This method can basically meet the needs of trace antibiotic residues detection in waters, with examples of concentrations of detected antibiotics being lower than LOQ (LLQ) -94.47 ng L^-1 in WWEs and LLQ-15.47 ng L^-1 in SW in the lower reaches of the Yangtze River Basin.