Related Experiment Video
Updated: Oct 16, 2025
Using Q Suture to Enhance Resistance to Gap Formation and Tensile Strength of Repaired Flexor Tendons
Published on: June 3, 2020
Placement of sutures for inside-out meniscal repair: both sutures through meniscal tissue reduces displacement on
Satoshi Yamakawa1, Tatsuo Mae2, Issei Ogasawara1,3
1Department of Sports Medical Biomechanics, Osaka University Graduate School of Medicine, 2-2, Yamada-oka, Suita, Osaka, 565-0871, Japan.
Purpose:
The inside-out meniscal repair is widely performed to preserve the function of meniscus. In this technique, the outer suture is passed through the capsule as well as the outer meniscus, while the inner suture is inserted into the meniscus. The aim of this study was to biomechanically compare the suture stability between meniscus-meniscus and meniscus-capsule suture methods for the longitudinal meniscal tear with inside-out technique.
Methods:
Twenty-seven porcine knees were dissected to maintain the femur-medial capsule/meniscus-tibia complex, and the inner meniscus was cut off along the meniscus circumferential fiber with 3 mm width of the peripheral meniscus preserved. After one needle with a 2-0 polyester suture was inserted into the inner portion of the meniscus, the other needle was inserted through 1) the peripheral meniscus (Group A), 2) capsule just above the meniscus (Group B), and 3) capsule at 10 mm apart from the meniscus-capsule junction (Group C) in the inside-out manner. Then, the suture was manually tied on the capsule. The suture gap at the repair site during 300 times of cyclic loading and the ultimate failure load in the load-to-failure test were measured. The statistical significance of the data between two groups in each combination was considered by Bonferroni correction, following a one-way analysis of variance.
Results:
In the cyclic loading test, the suture gap was 0.68 ± 0.26 mm in Group A, 1.08 ± 0.36 mm in Group B, and 1.94 ± 0.57 mm in Group C with a significant difference. In the load-to-failure test, the ultimate failure load was 59.1 ± 13.6 N in Group A, 60.0 ± 7.9 N in Group B, and 57.4 ± 4.7 N in Group C, and there was no significant difference.
Conclusion:
The stitching region in the inside-out technique for longitudinal meniscal tear affected the stability of the tear site, and stitching the mid-substance region of the meniscus provides good stability in response to cyclic tensile loading. In addition, the stitching region did not affect the ultimate failure load.
Clinical Relevance:
In the inside-out meniscal repair, the outer suture should be inserted into the remaining peripheral meniscus or the capsule near the meniscus.
