Related Experiment Video
Updated: Oct 16, 2025

Detection and Removal of Tooth-Colored Composite Resin Using the Fluorescence-Aided Identification Technique
Published on: July 27, 2022
Diagnosis of Dental Fluorosis Using Micro-Raman Spectroscopy Applying a Principal Component-Linear Discriminant
Marco Antonio Zepeda-Zepeda1,2, Michel Picquart2, María Esther Irigoyen-Camacho2
1Physics Department, Universidad Autónoma Metropolitana (UAM) Unidad Iztapalapa, Mexico City 09340, Mexico.
Abstract:
Dental fluorosis is an irreversible condition caused by excessive fluoride consumption during tooth formation and is considered a public health problem in several world regions. The objective of this study was to evaluate the capability of micro-Raman spectroscopy to classify teeth of different fluorosis severities, applying principal component analysis and linear discriminant analysis (PCA-LDA), and estimate the model cross-validation accuracy. Forty teeth of different fluorosis severities and a control group were analyzed. Ten spectra were captured from each tooth and a total of 400 micro-Raman spectra were acquired in the wavenumber range of 250 to 1200 cm-1, including the bands corresponding to stretching and bending internal vibrational modes ν1, ν2, ν3, and ν4 (PO43-). From the analysis of the micro-Raman spectra an increase in B-type carbonate ion substitution into the phosphate site of the hydroxyapatite as fluorosis severity increases was identified. The PCA-LDA model showed a sensitivity and specificity higher than 94% and 93% for the different fluorosis severity groups, respectively. The cross-validation accuracy was higher than 90%. Micro-Raman spectroscopy combined with PCA-LDA provides an adequate tool for the diagnosis of fluorosis severity. This is a non-invasive and non-destructive technique with promising applications in clinical and epidemiological fields.
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...

