Thermal and physical damage in skull base drilling using gas cooling modes: FEM simulation and experimental...

Skull base drilling, as a high-risk process, is one of the most important techniques of skull base surgeries.

The temperature, thrust force, and torque were calculated using finite element method (FEM) simulation under two conventional cooling models, and internal and external CO₂ cooling modes at four rotational speeds (1000-4000 rpm). The temperatures at the bottom and on the surface of the drilling site were measured experimentally using a thermometer and a thermographic camera, respectively. The results were then compared with FEM results.

The efficiency rates of CO₂ coolants in reducing the maximum temperature, thrust force, and torque were at least 5.0-11.2%, 16.5-33.8%, and 6.9-11.3% higher than conventional cooling modes, respectively. The experimental results indicated that, in contrast to the maximum temperature, temperature durability was 72.7-107.3% higher in the conventional cooling modes than the cooling modes with external CO₂ coolant systems. The cracks and surface defects were less in the CO₂ coolants than the other cooling modes. The maximum temperature after the second and third drillings increased by 17.7 and 26.8%, compared to the first drilling in the conventional cooling modes. On the other hand, the repeated drillings had no impact on the temperature in the CO₂ cooling modes.

Skull base drilling with a rotational speed of 2000 rpm in the cooling mode of an external CO₂ coolant, even for repeated drillings, can lead to a skull drilling process with minimum risk of drill bit breakage and thermal and physical damage.