Development of topical patches releasing allicin using garlic extract

Treating hair loss of Alopecia areata is a quite challenge. The treatment not only needs to be effective but must meet specific requirements in terms of accurate dose, sustain release, comfortable application with aesthetic appearance. Thus, the study was designed to develop sustained release topical patches releasing allicin using different sources, including the extract from fresh and aged garlic, and commercially pure one.

Patches were formulated by solvent casting method using ethylene-vinyl acetate as backing layer and Carbopol^® 971P NF (CP) as mucoadhesive polymer. Physicochemical properties were evaluated including weight, thickness, drug content, surface pH, moisture content, folding endurance, and swelling. In addition to in vitro diffusion study across the cellulose and Strat-M^® membranes.

Patches showed good physicochemical properties. No significant difference (p > 0.05) was obvious in the percentage of allicin diffused across cellulose membrane between patch A (loaded with commercial allicin), patch B1 (loaded with fresh garlic extract), and patch C (loaded with aged garlic extract). However, ethanol enhanced the diffusion of allicin. The percentage of allicin diffused across cellulose membrane over 20 h from patch E (45 mg CP, 2 mL fresh garlic extract-equivalent to 60 mg allicin-and 1 mL of ethanol) was 79.94%. The flux and permeability coefficients were 2.62 mg/cm² /h and 0.52 cm/h, respectively, with an enhancement ratio of 2.60 times the reference patch M (mashed garlic).

Promising development of topical patches of allicin using garlic extract as natural source with lower cost than the commercial pure allicin and higher aesthetic acceptance than the used mashed garlic.