Assessing long-term performance of stabilized Zn-contaminated dredged sediment slurry treated with the PHDVPSS method

Solidification/stabilization (S/S) has been widely used for effective treatment of dredged sediment (DS) for many years, with the objective of improving the mechanical properties of DS through the addition of inorganic cementitious materials. Most previous studies have reported the short-term performance of S/S. However, long-term effectiveness is critical, as contaminants remain underground and are subjected to a variety of environmental stresses that can degrade S/S materials. In this regard, this experimental work investigated the long-term efficacy of solidification/stabilization of dredged contaminated sediments (DCS) treated with a new integrated method, namely PHDVPSS, which uses a prefabricated horizontal drain (PHD) assisted by vacuum pressure (VP) as well as solidification/stabilization. The DCS were treated with Portland cement (PC) as binder in the PHDVPSS method (abbreviated as VP-PC) at different zinc (Zn) concentration levels and compared with the traditional cement-based solidification/stabilization method (abbreviated as SS-PC). A series of experimental tests such as unconfined compressive strength (UCS), toxicity characteristics leaching procedure (TCLP), X-ray diffraction (XRD) and scanning electron microscopy in conjunction with energy-dispersive spectroscopy (SEM-EDS) were performed to assess the long-term strength, leaching and microstructural characteristics of high-water-content DCS, respectively. The UCS test results indicated that the strength of VP-PC mixes increased significantly with curing time compared to the limited strength development of SS-PC mixes. After 180-day curing, VP-PC mixes exhibited 3.5-5.5 times higher UCS values than the SS-PC mixes. Furthermore, when compared to the SS-PC mixes, the VP-PC mixes had 14.7-36.4% lower leached Zn concentrations at different Zn levels. This is attributed to an increase in the least reactive F4 (residual) fraction and a decrease in the most mobile F1 (acid-soluble) fraction as confirmed by the BCR method. Microstructural tests including XRD and SEM-EDS revealed that calcium silicate hydrate-like compounds were identified as the main hydration products of both the VP-PC and SS-PC mixes. However, portlandite, a major hydration product of PC, was not detected in either case, which is attributed to the retardant effect of Zn on cement hydration. Overall, the experimental results showed that the PHDVPSS method, when compared to the conventional solidification/stabilization method, is a viable choice for treating high-water-content DCS at different Zn concentration levels with low cement content.