Investigation of Biochar Production from Copyrolysis of Rice Husk and Plastic

Biomass renewable energy has become a major target of the Thailand Alternative Energy Development Plan (AEDP) since the country's economy is largely based on agricultural production. Rice husk (RH) is one of the most common agricultural residues in Thailand. This research aims to investigate yields and properties of biochar produced from copyrolysis of RH and plastic (high-density polyethylene (HDPE)) at different ratios, temperatures, and holding times. For both individual and copyrolysis, the temperature variation generated more pronounced effects than the holding time variation on both biochar yields and properties. For individual pyrolysis of RH, the maximum biochar yield of ∼54 wt % was obtained at 400 °C. A shift in temperature from 400 to 600 °C resulted in RH biochars with higher fixed carbon (FC) and carbon (C) contents by ∼1.11-1.28 and 1.06-1.22 times, respectively, while undetectable changes in higher heating values (HHVs) were noticed. For copyrolysis, obvious negative synergistic effects were observed due to the radical interaction between the rich H content of HDPE and RH biochars, which resulted in lower biochar yields as compared to the theoretical estimation based on individual pyrolysis values. However, the addition of HDPE positively impacted the FC and C contents, especially when 10 and 20 wt % HDPE were added to the feedstock. Besides, higher HDPE blending ratios resulted in biochars with improved HHVs, and >1.5 times improvement in HHV was reported in the biochar with 50 wt % HDPE addition in comparison with RH biochar obtained under the same conditions. In summary, biochars generated in this study have the potential to be utilized as a solid fuel or soil amendment.