Related Experiment Video

Updated: Oct 13, 2025

Versatile CO2 Transformations into Complex Products: A One-pot Two-step Strategy
07:36

Versatile CO2 Transformations into Complex Products: A One-pot Two-step Strategy

Published on: November 9, 2019

8.1K

Competitive tetrel bond and hydrogen bond in benzaldehyde-CO2: characterization via rotational spectroscopy

Hao Wang1, Xiujuan Wang1, Xiao Tian1

  • 1School of Chemistry and Chemical Engineering, Chongqing University, Daxuecheng South Rd. 55, 401331, Chongqing, China. qian.gou@cqu.edu.cn.

Physical Chemistry Chemical Physics : PCCP
|November 10, 2021
PubMed

More Related Videos

Characterizing Lewis Pairs Using Titration Coupled with In Situ Infrared Spectroscopy07:49

Characterizing Lewis Pairs Using Titration Coupled with In Situ Infrared Spectroscopy

Published on: February 20, 2020

9.4K
Measurement and Analysis of Atomic Hydrogen and Diatomic Molecular AlO, C2, CN, and TiO Spectra Following Laser-induced Optical Breakdown09:40

Measurement and Analysis of Atomic Hydrogen and Diatomic Molecular AlO, C2, CN, and TiO Spectra Following Laser-induced Optical Breakdown

Published on: February 14, 2014

14.4K

Related Concept Videos

NMR Spectroscopy of Benzene Derivatives01:34

NMR Spectroscopy of Benzene Derivatives

Simple unsubstituted benzene has six aromatic protons, all chemically equivalent. Therefore, benzene exhibits only a singlet peak at δ 7.3 ppm in the 1H NMR spectrum. The observed shift is far downfield because the aromatic ring current strongly deshields the protons. Any substitution on the benzene ring makes the aromatic protons nonequivalent, and the protons split each other. The peak is, therefore, no longer a singlet and the splitting pattern and their associated coupling...
9.2K
Structure of Benzene: Molecular Orbital Model01:18

Structure of Benzene: Molecular Orbital Model

According to the molecular orbital (MO) model, benzene has a planar structure with a regular hexagon of six sp2 hybridized carbons. As shown in Figure 1, each carbon is bonded to three other atoms with C–C–C and H–C–C bond angles of 120°. The C–H bond length is 109 pm, and the C–C bond length is 139 pm which is midway between the single bond length of sp3 hybridized carbons (154 pm) and sp2 hybridized carbons (133 pm).
10.4K
IR and UV–Vis Spectroscopy of Aldehydes and Ketones01:29

IR and UV–Vis Spectroscopy of Aldehydes and Ketones

Infrared spectroscopy, also known as vibrational spectroscopy, is mainly used to determine the types of bonds and functional groups in molecules. In aldehydes and ketones, the carbonyl (C=O) bond shows an absorption around 1710 cm-1. The C=O bond vibration of an aldehyde occurs at lower frequencies than that of a ketone. In addition to the C=O absorption in an aldehyde, the aldehydic C–H bond also gives two peaks in the 2700–2800 cm-1 range. This absorption, coupled with the...
6.4K
Structure of Benzene: Kekulé Model01:07

Structure of Benzene: Kekulé Model

In 1865, August Kekule suggested the structure of benzene according to the structural theory of organic chemistry based on the three assertions—formula of benzene is C6H6, all the hydrogens of benzene are equivalent, and each carbon must have four bonds due to its tetravalency.
He proposed that benzene has a cyclic structure of six carbon atoms attached to one hydrogen atom each, with three alternating pi bonds.
10.4K
IR Spectrum Peak Broadening: Hydrogen Bonding01:23

IR Spectrum Peak Broadening: Hydrogen Bonding

The vibrational frequency of a bond is directly proportional to its bond strength. As a result, stronger bonds vibrate at higher frequencies, while weaker bonds vibrate at lower frequencies. The stretching vibration of the strong O–H bond in alcohols and phenols (very dilute solution or gas phase) appears as a sharp peak at 3600–3650 cm−1.
However, the extent of hydrogen bonding influences the observed stretching frequency and band broadening. Intermolecular or intramolecular...
1.3K
Reduction of Benzene to Cyclohexane: Catalytic Hydrogenation01:28

Reduction of Benzene to Cyclohexane: Catalytic Hydrogenation

Unlike the easy catalytic hydrogenation of an alkene double bond, hydrogenation of a benzene double bond under similar reaction conditions does not take place easily. For example, in the reduction of stilbene, the benzene ring remains unaffected while the alkene bond gets reduced. Hydrogenation of an alkene double bond is exothermic and a favorable process. In contrast, to hydrogenate the first unsaturated bond of benzene, an energy input is needed; that is, the process is endothermic. This is...
5.1K