Related Experiment Video
Updated: Oct 13, 2025

Use of Principal Components for Scaling Up Topographic Models to Map Soil Redistribution and Soil Organic Carbon
Published on: October 16, 2018
On Random Subspace Optimization-Based Hybrid Computing Models Predicting the California Bearing Ratio of Soils
Duong Kien Trong1, Binh Thai Pham1, Fazal E Jalal2
1Faculty of Civil Engineering, University of Transport Technology, 54 Trieu Khuc, Thanh Xuan, Hanoi 100000, Vietnam.
Abstract:
The California Bearing Ratio (CBR) is an important index for evaluating the bearing capacity of pavement subgrade materials. In this research, random subspace optimization-based hybrid computing models were trained and developed for the prediction of the CBR of soil. Three models were developed, namely reduced error pruning trees (REPTs), random subsurface-based REPT (RSS-REPT), and RSS-based extra tree (RSS-ET). An experimental database was compiled from a total of 214 soil samples, which were classified according to AASHTO M 145, and included 26 samples of A-2-6 (clayey gravel and sand soil), 3 samples of A-4 (silty soil), 89 samples of A-6 (clayey soil), and 96 samples of A-7-6 (clayey soil). All CBR tests were performed in soaked conditions. The input parameters of the models included the particle size distribution, gravel content (G), coarse sand content (CS), fine sand content (FS), silt clay content (SC), organic content (O), liquid limit (LL), plastic limit (PL), plasticity index (PI), optimum moisture content (OMC), and maximum dry density (MDD). The accuracy of the developed models was assessed using numerous performance indexes, such as the coefficient of determination, relative error, MAE, and RMSE. The results show that the highest prediction accuracy was obtained using the RSS-based extra tree optimization technique.
Related Concept Videos
Mechanistic Models: Compartment Models in Algorithms for Numerical Problem Solving
In individual population analyses, different algorithms are employed, such as Cauchy's method, which uses a...
Resultant of a General Distributed Loading
Examples such as load distribution due to wind and load distribution on a bridge illustrate how this concept is used to analyze and design safe, reliable structures under variable loading conditions. Most structures, such as residential buildings, bridges, and towers, are...
Moisture Content and Bulking of Aggregate
When aggregates are exposed to rain or sit in stockpiles, they absorb moisture, which must be...
Dynamic Modulus of Elasticity of Concrete
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by...
Relation Between the Distributed Load and Shear
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...

