Related Experiment Video
Updated: Oct 11, 2025

In Vivo Measurement of Hindlimb Dorsiflexor Isometric Torque from Pig
Published on: September 3, 2021
Effects of vibration and passive resting on muscle stiffness and restitution after submaximal exercise analyzed by
Wiesław Chwała1, Paweł Pogwizd2
1Department of Biomechanics, University of Physical Education in Krakow, Kraków, Poland.
Purpose:
The research aimed to assess the influence of vibration therapy on acceleration of muscles regeneration process after physical effort. Verification of the pace of motor capabilities recovery in fatigued muscles was performed with the use of the measurement method applying shear-wave elastography. It took into account an alteration in muscle stiffness affected by created passive stresses and accompanying deformations connected with muscles work above their resting length.
Methods:
The research included 42 young males aged 20-24. They all were a homogeneous group regarding body build indices (body height 175.4 ± 8.1 cm; body mass 75.5 ± 8.32 kg) and the level of physical activity. Muscles of lower limbs (hip and knee joints extensors and flexors plantaris) were subject to submaximal exercise of the auxotonic muscle work character after a 90 s warm-up. The exercise comprised 20-fold overcoming the load at the level of 75% of maximal strength abilities without rest, by alternating between extension and flexion of lower limbs joints at the leg press placed at 45° angle upward and monitoring of angle setting of lower limbs joints. The post-exercise restitution used a vibration stimulus of variable frequency ranging from 20 to 50 Hz and amplitude of 0.5 mm, and passive resting in the control group. For an objective assessment of the applied vibration effect, a 5-fold measurement of rectus femoris muscles stiffness of both limbs at the middle of venter took place after each stage of the experiment.
Results:
After warm-up, a considerable increase of the examined muscles stiffness, that did not vary significantly, was observed. In the DW experimental group (vibration massage), where post-exercise restitution was enhanced by vibration, significantly lower values of muscle stiffness were registered after each of the post-exercise regeneration stages in relation to the DB control group (passive rest). After the I regeneration stage, a value of the Δσ_r1-s variable ( p < 0.05) lower by 16% was noticed in favour of the group enhanced by vibration. Whereas, values of muscles stiffness after the II stage of regeneration, Δσ_r2-s were by 14% lower in favour of DW group ( p < 0.005).
Conclusions:
Enhancement of the post-exercise relaxation of muscles by vibration treatment significantly lowered the values of post-exercise muscles stiffness and turned out to be a more effective method of restitution than passive resting. Recovery of the level of muscles stiffness from before the exercise was much slower in the control group than in the one enhanced by vibration. The improved method of muscle stiffness measurement with the use of shear-wave elastography with a special head attachment turned out to be a useful tool to assess post-exercise muscles restitution.
Related Concept Videos
Relaxation of Skeletal Muscles
When an action potential reaches the axon terminal, it depolarizes the membrane and opens voltage-gated sodium channels. Sodium ions enter the cell, further depolarizing the presynaptic membrane. This depolarization causes voltage-gated calcium channels to open....
Muscle Stimulation Frequency
Wave summation
At low firing rates, motor neurons induce individual twitch contractions in muscle fibers. These twitches...
Elastin is Responsible for Tissue Elasticity
Ligaments and tendons are made of dense regular connective tissue, but in ligaments not all fibers are parallel. Dense regular elastic tissue contains elastin fibers and...
Strain and Elastic Modulus
Dynamic Modulus of Elasticity of Concrete
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by...

