Related Experiment Video
Updated: Oct 10, 2025

Enhanced Oil Recovery using a Combination of Biosurfactants
Published on: June 3, 2022
Dissolution and remobilization of NAPL in surfactant-enhanced aquifer remediation from microscopic scale simulations
Mehdi Ramezanzadeh1, Morteza Aminnaji2, Fereidoun Rezanezhad1
1Ecohydrology Research Group, Department of Earth and Environmental Sciences and Water Institute, University of Waterloo, Waterloo, ON, Canada.
Abstract:
In this paper, the dissolution and mobilization of non-aqueous phase liquid (NAPL) blobs in the Surfactant-Enhanced Aquifer Remediation (SEAR) process were upscaled using dynamic pore network modeling (PNM) of three-dimensional and unstructured networks. We considered corner flow and micro-flow mechanisms including snap-off and piston-like movement for two-phase flow. Moreover, NAPL entrapment and remobilization were evaluated using force analysis to develop the capillary desaturation curve (CDC) and predict the onset of remobilization. The corner diffusion mechanism was also applied in the modeling of interphase mass transfer to represent NAPL dissolution as the dominant mass transfer process. In addition, the effect of pore-scale heterogeneity on mass transfer rate coefficient and recovered residual NAPL was considered in the simulations. Sodium dodecyl sulfate (SDS) and Triton X-100 were used as the surfactant for the SEAR process. The results indicate that although surfactants enhance NAPL recovery during two-phase flow, surfactant-enhanced remediation of residual NAPL through dissolution is highly dependent on surfactant type. When SDS ─as a surfactant with high critical micelle concentration (CMC) and low micelle partition coefficient (Km)─ was injected into a NAPL contaminated site, the mass transfer rate coefficient decreased (due to considerable changes in interface chemical potentials) which leads to a significant reduction in NAPL recovery after the end of two-phase flow. In contrast, Triton X-100 (with low CMC and high Km) improved NAPL recovery, by enhancing solubility at surfactant concentrations greater than CMC which overcompensates the interphase mass transfer reduction.
More Related Videos
Related Concept Videos
Factors Affecting Dissolution: Particle Size and Effective Surface Area
Theories of Dissolution: The Danckwerts' Model and Interfacial Barrier Model
Theories of Dissolution: Diffusion Layer Model
This process starts with a thin layer, saturated with the drug, forming at the interface between the solid and liquid. The solute then diffuses from this layer into the main solution. The Noyes-Whitney equation suggests that the rate of dissolution relies on the diffusion...
Factors Affecting Solubility
Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules,...

