Measurement of 5- fluorouracil, capecitabine and its metabolite concentrations in blood using volumetric absorptive...

5-fluorouracil (5-FU) and its oral formulation, capecitabine, are widely used in treating a range of malignancies, either alone or in combination with other antineoplastic drugs. Body surface area-based dosing is used for these agents, despite this approach leading to substantial variability in drug exposure and often resulting in either toxicity or treatment failure. Tailoring therapeutic regimens for individual patients using therapeutic drug monitoring (TDM) has been shown to significantly reduce toxicity and improve cancer outcomes. However, for optimum TDM, sample timing is crucial, along with the need for a venepuncture blood sample to obtain the plasma currently used for 5-FU measurement. In addition to complex blood sample handling requirements, large sample volume and frequent sampling required for pharmacokinetic analysis is another barrier to successfully implementing TDM in a healthcare setting. Microsampling is an alternative collection method to venepuncture, which, combined with the now readily available liquid chromatography mass spectrometry (LC-MS/MS) technology, overcomes the plasma-associated issues. It also has the significant advantage of enabling at home and remote sampling, thus facilitating 5-FU TDM in clinical practice. A LC-MS/MS method for simultaneous measurement of capecitabine, 5'-deoxy-5-fluorocytidine, 5'-deoxy-5-fluorouridine and 5-FU using Mitra® microsampling devices for sample collection was developed. A Shimadzu 8060 LC-MS/MS equipped with electrospray ionisation source interface, operated in positive and negative ion modes, with reversed-phase chromatographic separation was employed for sample analysis. Samples were extracted from Mitra® devices using acetonitrile containing stable isotope-labelled internal standards, sonicated, evaporated under vacuum and resuspended in 0.1 % formic acid before injection into the LC-MS/MS. Chromatographic separation was on a Luna Omega Polar C₁₈ (100 × 2.1 mm, 1.6 µm) column with gradient elution of 0.1 % formic acid in water and acetonitrile. Total run time was 5 min, with the injection volume of 1 µL. The intra and inter-day imprecision ranged from 3.0 to 8.1 and 6.3-13.3 % respectively. Accuracy ranged from 95 -114 % for all analytes. Lower limit of quantification with imprecision of < 19 % and accuracy between 89 and 114 % was 0.05 mg/L for 5-FU and 10 µg/L for other analytes. Assays were linear from 0.05 to 50 mg/L for 5-FU and 10-10,000 µg/L for all other analytes. Analytes were stable on Mitra® devices for up to 9 months at room temperature, 2 years at -30 ℃ and 3 days at 50 ℃. The method was successfully applied for the analysis of samples from patients undergoing cancer treatment with 5-FU and capecitabine. Microsampling using volumetric absorptive microsampling proved to be as reliable as conventional blood collection for 5-FU and capecitabine. This sampling technique may lead to less invasive and better-timed sample collection for TDM, supporting dose optimization strategy.