An ASK Data Demodulator Circuit for Implantable Medical Devices Supporting a Minimum Modulation Depth of 0.034

Amplitude shift keying (ASK) data demodulation method has been widely used for simultaneous wireless data and power transfer in implantable medical devices (IMDs). Small amplitude modulation depth (MD) is usually preferred as it helps promote energy harvesting efficiency. This paper presents an ASK data demodulator that has good immunity to disturbances and can demodulate ultra-low MD ASK signal. A three-stage amplifying structure (3SAS) is proposed, in which the common-mode level of each amplifier is set between the high and low levels of its input signal envelope to prevent amplifier gain saturation and maximize the amplification of the envelope difference. Two envelope detectors (EDs) are used before and after the 3SAS respectively. The first one is to obtain a coarse envelope for 3SAS input and the second one is to further suppress the residual carrier interference and get a fine envelope. The proposed demodulator is implemented in 0.18-μm high-voltage Bipolar-CMOS-DMOS (BCD) technology. The detectable MD is measured as low as 0.034%, showing that the proposed demodulator can work smoothly and robustly in some extreme cases of simultaneous data and power transferring.Clinical Relevance- The ASK data demodulator proposed in this paper supports ultra-low modulation depth. This reduces the bit error rate of the data link and keeps a highly power conversion efficiency for wireless power and data transfer in implantable medical devices.