Related Experiment Video
Updated: Oct 10, 2025

A Whole Body Dosimetry Protocol for Peptide-Receptor Radionuclide Therapy PRRT: 2D Planar Image and Hybrid 2D+3D SPECT/CT Image Methods
Published on: April 24, 2020
Technical note: Advancing size-specific dose estimates in CT examinations: Dose estimates at longitudinal positions
Xinhua Li1, Theodore A Marschall1, Kai Yang1
1Department of Radiology, Massachusetts General Hospital, Harvard Medical School, Boston, Massachusetts, USA.
Purpose:
American Association of Physicists in Medicine (AAPM) (Report 204) introduced the size-specific dose estimate (SSDE) for the average dose to the center of a fixed-mA scan. International standards establish a method that CT manufacturers and radiation dose index monitoring software may use to calculate SSDE(z) at longitudinal positions of scans with fixed mA or tube current modulation, and its scan range average . We sought to test how accurate SSDE(z) is in tracking the average dose to the transverse slab of an axial image slice (Dslice ), evaluated with Monte Carlo calculation, in the chest and abdominopelvic examinations.
Methods:
We retrospectively identified 65 consecutive adult patients undergoing whole-body CT for transcatheter aortic valve implantation planning. Examination parameters (kV, mA, CTDIvol ) were extracted from the DICOM headers. Patient water equivalent diameter DW (z) was calculated at each image slice, excluding the patient table. A previously validated Monte Carlo simulation (Geant4) program was used to evaluate Dslice from the chest and abdominopelvic examinations. Alternatively, SSDE(z) was calculated at each slice. The results of the two methods were compared with descriptive statistical outcomes (R, version 4.0.2).
Results:
In chest and abdominopelvic CT examinations, Dslice largely changed with anatomic location and uniformly fell off toward scan range edges. Scan range averages and were consistent within 2.5%-3.1% (median) and 6.3%-10.4% (maximum) in two examinations. On individual image slices, SSDE(z) could be lower or higher than Dslice , with deviation ranging from -18.3% to 85% in two edges (2 × 5 cm) of scan range and from -35.2% to 18.7% in the remaining central region of the scan.
Conclusion:
This study provides critical inputs for quality assurance programs. is useful to track the average dose of all image slices, but further development may be useful for tracking patient dose at the level of individual image slices, especially near a scan range edge.
More Related Videos
Related Concept Videos
Computed Tomography
The technique was invented in the 1970s and is based on the principle that as X-rays pass through the body, they are absorbed or reflected at different levels. In the technique, a patient lies on a motorized platform while a computerized axial tomography (CAT) scanner rotates...
Imaging Studies for Cardiovascular System V: CT
Imaging Studies II: Positron Emission Tomography and Scintigraphy
Fundamental Principles of PET
Imaging Studies I: CT and MRI
Description of the Procedures
Computed Tomography (CT) scan:
Computed Tomography (CT) scans use X-ray technology to generate detailed images of bones, organs, and tissues. During the scan, the patient lies on a moving table...
Radiological Investigation I: X-ray and CT

