Related Experiment Video
Updated: Oct 9, 2025

Asymmetric Thermoelectrochemical Cell for Harvesting Low-grade Heat under Isothermal Operation
Published on: February 5, 2020
Towards decarbonisation targets by changing setpoint temperature to avoid building overcooling and implementing
Yu Ting Kwok1, Robert Schoetter2, Edward Ng1
1School of Architecture, The Chinese University of Hong Kong, Hong Kong, China.
Abstract:
Climate warming, rapid economic development, and urbanisation in (sub)tropical regions lead to increasing electricity demand for building air-conditioning that could jeopardise the efforts of decarbonisation required to meet the climate change mitigation goals. This study investigates two strategies to reduce building energy consumption due to air-conditioning: 1) the bottom-up adoption of an Adaptive Thermal Comfort (ATC)-based cooling setpoint temperature and 2) the top-down implementation of efficient District Cooling Systems (DCS). The subtropical high-density city of Hong Kong is chosen for case study since detailed data on the city's current and realistic future urban form and function are available. Numerical simulations representing the feedback between urban climate and building energy consumption are conducted by employing a mesoscale atmospheric model coupled to an urban climate and building energy model for a scenario of future (mid-21st century) Hong Kong. A prolonged high temperature event representative of future extreme conditions is simulated, during which the ATC and DCS strategies reduce building cooling energy consumption by 9.7% and 5.9%, respectively. The ATC has almost no effect on the local meteorological conditions, whereas the DCS reduces daytime sensible heat flux by up to 600 W/m2 and near-surface air temperature by almost 1 °C in the districts where it is adopted. The DCS thus also contributes to lowering outdoor heat stress in these areas. The cost-free ATC strategy is easily applicable in residential buildings worldwide and can break the vicious cycle in overcooled buildings, where occupants are acclimatised to lower indoor temperature and thus require more air-conditioning than necessary. Apart from reducing energy consumption and near-surface air temperature, the DCS brings additional benefits in building space utilisation and rooftop design. Future policy orientations should therefore encourage a societal change towards the ATC lifestyle and incorporate DCS in the planning of new development areas.
More Related Videos
Related Concept Videos
Global Climate Change
Hot Weather Concreting
Mitigating the heat increase in concrete can be economically achieved by shading aggregate stockpiles to prevent heating from solar radiation,...
Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q, and its...
Design Example: Sustainability in Concrete Building
There are multiple approaches to achieve sustainability in a commercial concrete building. For instance, construct a concrete parking area under the building, utilizing pervious concrete paver blocks in open areas to facilitate rainwater collection through an underground...
Mass Concreting
To reduce the risk of such cracking, the concrete mix may incorporate low-heat cement and pozzolans to reduce the temperature rise. Pre-cooled angular aggregates and water-reducing admixtures...
Design Example: Managing Concrete Workability

