Related Experiment Video
Updated: Oct 9, 2025

Visually Sexing Loggerhead Shrike Lanius Ludovicianus Using Plumage Coloration and Pattern
Published on: March 8, 2020
Cone distribution and visual resolution of the yellow-legged gull, Larus michahellis (Naumann, 1840)
Noemi Victory1, Yolanda Segovia1, Magdalena García1
1Department of Biotechnology, Faculty of Science, University of Alicante, Alicante, Spain.
Abstract:
The morphological characteristics of the yellow-legged gull's photoreceptors and cone distribution were studied using light and electron microscopy. In wholemount fresh retinas, five different coloured oil droplets located in the cone inner segments could be seen and characterized by colour, diameter and stratification. The photoreceptors were classified by comparing the fresh and fixed vertical sections under a light and electron microscope. Rods were easily distinguished from cones based on the outer segment morphology and the absence of oil droplets in their inner segments. Four types of single cones were associated with red, yellow, colourless and transparent oil droplets. Unequal double cones comprised a long principal member with a green oil droplet and an accessory short member containing a green microdroplet which was highly electron-dense under electron microscopy. The different types of oil droplets were counted from microphotographs of fresh retinal samples in 20 regions. The density, percentage and diameter of the oil droplets were determined. The results showed that central regions had the highest oil droplet density which decreased towards the retinal periphery in all quadrants. Moreover, the oil droplet density was higher in the dorsotemporal quadrant than in other retinal regions. The average density of the red oil droplets was highest in the central areas, whereas colourless oil droplets had the highest density throughout the retina. In contrast, transparent oil droplets had the lowest density across all the regions of the retina. Finally, the retinal resolution was 52.61 cycles/degree. It was calculated using the posterior nodal distance and the oil droplet diameter. The work concludes by discussing the significance of the relative proportion of different cone types across the retina.
Related Concept Videos
Testing a Claim about Mean: Unknown Population SD
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used;...
Anatomy of the Eyeball
Distribution and Dispersion
Testing a Claim about Population Proportion
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
Mate Choice
Lethal Alleles
Lucien Cuénot discovered lethal alleles in 1905 while studying the inheritance of coat color in mice. The agouti gene is responsible for the color of the coat in mice. This gene codes for an agouti-signaling protein, which is responsible for melanin distribution in mammals. The wild-type allele gives rise to gray-brown coat color in mice, while the mutant allele gives rise to yellow coat color. In addition to coat color, the agouti gene is associated with the yellow...

