Portable fluid circuit device containing printed silicone microvessels as a training aid for arterial...

Anastomosis of the microvessels requires high-level skills and extensive basic training. This study was performed to introduce and evaluate an inexpensive laboratory device as a training aid. Micro-tubes of 0.8 mm inner diameter and 0.5/0.8 mm wall thickness mimicking human vein/artery were printed from a silicon-containing hydrogel using three-dimensional printing technology. The hydrogel components are optimized to render the printed tubes biomechanical features resembling the blood vessels of a living organism. These artificial vessels were connected to a pump for fluid flow, simulating the blood circulation. Forty medical interns were assigned to two equal groups. The 20 interns in group A practiced anastomosis using the training aid for a total of 10 hours over 5 days. The 20 interns in group B practiced anastomosis using the traditional gum pieces and silicone tubes. Then, all interns performed anastomosis on rat carotid arteries, and their performance was scored by a team of five experienced maxillofacial surgeons. The average success score and time required for anastomosis were compared between the two groups. The mean success score of group A was significantly higher than that of group B (0.83 ± 0.12 vs 0.64 ± 0.10, P < 0.001). The mean anastomosis time of group A was significantly shorter than that of group B (10.2 ± 1.1 vs 17.2 ± 1.4 minutes, P < 0.001). This training device for vessel microanastomosis is an inexpensive, practical, and effective tool for use in laboratories and also reduces the use of animals.