Related Experiment Video
Updated: Oct 8, 2025
Experimental Protocol to Investigate Particle Aerosolization of a Product Under Abrasion and Under Environmental Weathering
Published on: September 16, 2016
Effects of lower alcohols on nanocomposite particles for inhalation prepared using O/W emulsion
Issei Takeuchi1,2,3, Yukie Kimura1, Takehisa Nakajima2
1Faculty of Pharmaceutical Sciences, Tokyo University of Science, Yamazaki, Noda, Chiba, Japan.
Background:
Inhalable nanocomposite particles using O/W emulsions were studied. The effect of the composition of the dispersed phase on the nanoparticles in the nanocomposite particles was reported, however, the effect on the inhalation characteristics of nanocomposite particles has not been investigated.
Objective:
The aim of this study was to study the effects of lower alcohols in the dispersed phase of O/W emulsions on inhalable nanocomposite particles.
Methods:
Nanocomposite particles were prepared using a spray dryer from O/W emulsion. A mixed solution of dichloromethane and lower alcohols in which rifampicin (RFP) and poly(L-lactide-co-glycolide) were dissolved was used as a dispersed phase, and an aqueous solution in which arginine and leucine were dissolved was used as a continuous phase.
Results:
We succeeded in preparing non-spherical nanocomposite particles with an average diameter of 9.01-10.91 μm. The results of the fine particle fraction (FPF) measurement showed that the higher the hydrophobicity of the lower alcohol mixed in the dispersed phase, the higher the FPF value. The FPF value of the nanocomposite particles was significantly increased by using ethanol and 1-propanol.
Conclusions:
The results were revealed that mixing 1-propanol with the dispersed phase increased the amount of RFP delivered to the lungs.
Related Concept Videos
02:17Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
02:29Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
02:32Physical Properties of Alcohols and Phenols
Alcohols possess a higher boiling point than aliphatic hydrocarbons of...
02:15Preparation of Alcohols via Addition Reactions
The acid-catalyzed addition of water to the double bond of alkenes is a large-scale industrial method used to synthesize low-molecular-weight alcohols. An acidic atmosphere is required to allow the hydrogen in the water molecule to act as an electrophile and attack the double bond in an alkene. The addition of a proton to the double bond creates a carbocation intermediate. The proton preferentially bonds to the less substituted end of the double bond to create a more stable carbocation...
02:23Alcohols from Carbonyl Compounds: Reduction
Catalytic hydrogenation is similar to the reduction of an alkene or alkyne by adding H2 across the pi bond in the presence of transition metal catalysts like Raney Ni, Pd–C, Pt, or Ru. Aldehydes and ketones can be reduced by this method, often under mild to moderate heat (25–100°C) and...
01:19Aldehydes and Ketones with Alcohols: Hemiacetal Formation