The measurement of molecular interactions, structure and physical properties of okara cellulose composite hydrogels...

Aiming to address the practical problems of a low utilization rate and the serious waste of soybean residue, novel composite hydrogels based on okara cellulose before and after 2,2,6,6-tetramethylpiperidine oxide (TEMPO) oxidation and high polymers of chitosan (CH), carrageenan (CA) or Arabic gum (AG) were prepared by a homogeneous mixture in ionic liquid.

In the present study, composite hydrogels fabricated from okara cellulose and CH, CA or AG were prepared by dissolving them in an ionic liquid, followed by heating (100 °C, 3 h) and then soaking them in a 1:1 water-isopropanol solution. The composite hydrogels prepared from TEMPO oxidation-treated cellulose were physically cross-linked to CH, CA or AG. The results showed that the intramolecular hydrogen bonds in the amorphous regions of the cellulose were disrupted, whereas the intermolecular hydrogen bonds between the biopolymers were increased, which promoted the formation of composite gels with crystalline structures. The TEMPO treatment increased the gel strength. For example, for the cellulose/CA gels, the hardness, fracturability, springiness and cohesiveness values were 5.9-, 4.3-, 2.4- and 3.6-fold higher compared to the non-treated ones, respectively. The composite hydrogels exhibited good thermal stability, swelling properties and mechanical properties. These novel composite polysaccharide-based hydrogels may therefore have great potential in various food and non-food fields.

In summary, the addition of polymers (CH, CA or AG) and TEMPO oxidized cellulose was suitable for increasing the swelling, textural properties, thermal stability and rheological properties of hydrogels, which provides new ideas and new methods for the preparation of bio-based composite hydrogels. © 2022 Society of Chemical Industry.