Determination of Glyphosate and AMPA in Food Samples Using Membrane Extraction Technique for Analytes...

The method for determining glyphosate (NPG) and its metabolite AMPA (aminomethyl phosphonic acid) in solid food samples using UAE-SLM-HPLC-PDA technique was developed. Firstly, ultrasonic-assisted solvent extraction (UAE) and protein precipitation step were used for the analyte isolation. Then, the supernatant was evaporated to dryness and redissolved in distilled water (100 mL). The obtained solution was alkalized to pH 11 (with 1 M NaOH) and used directly as donor phase in SLM (supported liquid membrane) extraction. The SLM extraction was performed using 2 M NaCl (5 mL) as an acceptor phase. The flow rate of both phases (donor and acceptor) was set at 0.2 mL/min. The membrane extraction took 24 h but did not require any additional workload. Finally, the SLM extracts were analyzed using the HPLC technique with photo-diode array detector (PDA) and an application of pre-column derivatization with p-toluenesulfonyl chloride. Glyphosate residues were determined in food samples of walnuts, soybeans, barley and lentil samples. The LOD values obtained for the studied food were 0.002 μg g^-1 and 0.021 μg g^-1 for NPG and AMPA, respectively. Recoveries values ranged from 32% to 69% for NPG, 29% to 56% for AMPA and depended on the type of sample matrix. In the case of buckwheat and rice flour samples, the content of NPG and AMPA was below the detection level of a used analytical method.